edgar.reinke
Level 1
Level 1
Member since ‎01-03-2005
‎10-08-2024

User Statistics

  • 36 Posts
  • 2 Solutions
  • 5 Helpful votes Given
  • 20 Helpful votes Received

User Activity

Hi,I started to discover the new CAT3850 switch and it seems to be that I fail with a basic setup: I am not able to terminate the CAPWAP tunnel from an Access Point (3502E) on the CAT3850.The AP is directly connected to the switch. I am using VLAN10 ...
The RME (Config Archive Management)of our LMS3.0 installation reports a lot of out-of-sync devices.Most of same are based on <no scheduler allocated>, <terminal length> etc. which is not really important for us to see. Therefore, we have excluded the...
When PIX forwards an ARP Request in transparent mode, it inserts its own (!) mac address as source in the ethernet header. So it is not really transparent. E.G.:Original ARP Request:ETH Source: PCETH Destination: RouterARP Sender HW: PC IP: PCARP Rec...
I have a brand new PIX-515E, which was delivered with R7.X. Nevertheless, I have to downgrade the pix to R6.3.This seems to be a problem, because with the downgrade command I have to enter a 4-tuple activation key. But I do not have one, because I´am...
Does anybody know (or have a link) why there are still 2 release lines for Concentrator 3000 Series: 4.1 and 4.7 ... and what are the major differences?Thanks in advanceEdgar
Community Statistics
Member Since ‎01-03-2005 02:12 PM
Date Last Visited ‎10-08-2024 03:50 AM
Posts 36
Total Helpful Votes Received 19
Helpful Votes From
Helpful Votes Given To