Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,I have a cisco router configured with MGCP to the call manager. FXO ports shown as registered in the CUCM but FXO is no not working.It shows in the Cisco Voice GW as ring-dect then up status. and keeps ringing or some time ring once and disconn...
Dears,Hope you are doing wellI have the following scenario; Error "SIP/2.0 404 Not Found" CME (ver 8.5) SCCP IP Phone(212)-->LAN(SIP Trunk)-->Grand Stream UCM 6208 Device--> SIP IP phone(6000)--> Fast Busy Signal......But the opposite direction wo...
Dear All,am having cisco cme router 2921 with version 9 cme.I need to get the calls log reports in the same format of cme report-->call history (start time - originating number - destination number - duration) for a long period of time like 3-6 month...
Dear all,I have an old CUCM7-BE (MCS7828H3-K9-BE7) with about 1800 DLU units (only 900 DLU used) in addition to 50 mail box in the unity connection. Branches there are MGCP gateways works also in SRST when CUCM fails. Models are (2851,2811,1861,2911 ...
Dear all,
I have 3 FTDs 2100 version 6.2.3 connected and configured by Virtual FMC (6.2.3). Two of the three FTDs are configured in HA mode as per attached.
I want to break the HA in which FTD_02 which is the active (as attached) keeps working and pr...
Dear Scott,This post is for after the internal phone rings but don't hand up, my issue is at the beginning in which I want my internal phone number to ring, it keeps showing ring-det status then up status only with ring tone sound. regards,
Hi Nithin again,Ignore any PLAR setting under the voice ports, it is already removed. Yes MGCP is rare but this settings is working fine for 10 years till last week. Attached is the MGCP CUCM settings as requested.All previous issues for the whole pe...
Thanks Scott for your replay.here you go for the main show run settings as per requested. The difference in the error code , i think because of the different applied settings under the voice ports as some times caller hears ringing tone only and some...
Hi again Nithin,Both of your above configuration was already there,i have attached you another debug files for two test calls as below:The first call is to voice-port 0/0/1 and the second call is to voice-port 0/0/0.Calling number: 771484383Called id...