Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I accidentally removed the enable secret password but still have access to exec mode(telnet and console). When I tried to go to enable mode, it prompted "% no password set". How do I get/set to use priviledge mode again? THANKS.
All,Appreciate if anyone can suggest a proper interface configuration in Cat3550 when connected to a Cisco828(which is connected to another 828 via a pair of copper cable, something like extended the LAN from Cat3550). Thanks for any responses.
Hello Netpros,I have 2 routers linked together with 3 leased lines of 512k, 1mb and 2mb. Both routers are running OSPF with the links using OSPF authentication. Until now I cannot seem to find a way to use OSPF to load-balance the links evenly and ha...
My Ciscoworks log files have exceeded the file size limit. Question 1)How do I increase size limit? Question 2)How do I open an old 2 gigabyte log file that's not residing in the default log folder?.Many thanks for any responses.MsaufiMalaysia
Anyone,When telnetting to my router, I'm prompted with Username and anything that key-in , the router responded with "% Login Invalid". I suspected that I did not configured e.g "username me privilege 1 password test" earlier on and I also think that...
Rick,Yes, telnet works fine but not on priviledge access. From console port, yes your are right, priviledge mode is allowed and I'm able to set enable secret again, so no need for password recovery anymore. Many thanks. Morshidi
Layer 2 all the way from the end 828<-->828<-->Cat3550(DHCP server sits here). I'm referring to Cat3550 fastethernet interface configuration that connects to 828 and was thinking whether something like below can help:switchport mode accessspanning-t...
Thanks Kannan.Yes,PPP links will probably not help much.Both of my routers supports CEF and infact it's already enabled. But your url to CEF load balancing helps me understand better about CEF.Will try either the load-sharing per-packet or per destin...
Amit,Appreciate your fast repsonse.Already tried OSPF cost, but the end results is not what I wanted.For PPP multilink, I'm still trying to get the right configuration. If you can direct me to the right source or url, then it will probably helps a lo...
Tekha,Thanks for the prompt response.Yes indeed OSPF can't do unequal loadbalancing.I've tried playing with cost but always ended up the lowest bandwidth being heavily utilised.EIGRP is a no go since that's where I've migrated from. Now looking at PP...
