Hi all,i have an issue with the CME GUI.normally when we add new phones to the network the phone will appear on the GUI.but one of the phone is not appearing.but this phone is registered.can able to configure using CLI.what could be the cause?thanksk...
Hi all,i have an issue with the CME GUI.normally when we add new phones to the network the phone will appear on the GUI.but one of the phone is not appearing.but this phone is registered.can able to configure using CLI.what could be the cause?thanksk...
HI all,one of the cutomer contact center is running in uccx 7.0(1). the Agents are using CAD to answer the calls.this cutomer wants ,after the conversation with the caller,when the agent press "end call button" on the CAD,it should redirect to a ...
How many IP phones does UC560 support?Datasheet indicating 138.but addition of max-ephones under telephony service , max pool under voice register global are more than 138.
I slotted the vic2-fxo card into the ISR 2911.but in the running config there is no port available.when issueing the cmd show inventory,the fxo card is available.what other configuration should be done to enable this voice-port?.note that there is no...