Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am unable to export an Insert User BAT file when adding info to the IPCC Extension Field.Example:203 Extension in INTERNAL-PT303 Extension in INTERNAL-PTThe 203 will be the Primary ExtensionThe 303 will be the IPCC ExtensionUsers (BAT)Assumtion tha...
Is it correct that based on the debug below that extension 1437 is sending its NAME (Display i". And would it be up to the GW (PBX) accepting this call to process the "Display i =" information.May 11 17:15:44.225 est: ISDN Se6/0:23 Q931: TX -> SETUP ...
We are upgrading our phone network to Cisco AVVID. We need to interate our AVVID platform during the upgrade with a Nortel BCM. Our only option will be using H323 for interoperability.I have supplied a message from a Nortel Eng. as to why the 2 will ...
Tip: if you plan to use an FXS port to drive a horn or ringer of some type you will more than likely need to boost the ring voltage. We used this product from Viking Model: RG-10A. The FXS ports put out between 30 and 40v AC for ring voltage and most...
You mention that the Calling Name in the Facilities IE is not supported by CCM using H323. If this were an MGCP GW would that make a difference. Also the mention of the Facilities IE and the Display IE information elements has raised more questions f...
I have run into the same issue with the VG248 these ports only output 45vAC ring voltage. I needed 90vAC. I finally found the following product from Viking the RG-10A.http://www.vikingelectronics.com/Here are the specsPower: 120V AC/13.5V AC 1.25A UL...
