Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are planning to purchase ASR 1001-HX Router because of the 10 GE ports. We were quoted for four FLSA1-HX-2X10GE and we only need four 10 GE ports. What I understand on the link below is that ASR by default, the first 4 ports on bay 0 and bay 1 can...
Hi All,
We had a power outage last night and site has 1231 AP and local 4402 WLC. After the power outage all AP no longer joining the WLC. WLC can reach the AP's, AP's has the correct firmware base on CDP NEI. WLC output below and no AP EthernetMAC....
I have 2 Data center and both advertise 10.50.110.0/24 because each data centre has SVI vlan 110 configured. I want to all route to destination 10.50.110.0/24 to go to DC2 so I decided to add delay 100 in interface vlan 110 at DC1. After adding the c...
I am planning to configure OTV in ASR1001X router and during my research I found this article.
"The current OTV implementation on the Nexus 7000 enforces the separation between SVI routing and OTV encapsulation for a given VLAN. This separation can ...
HI All,
Just want to confirm if any effect or bad configuration if the Service Instance in Overlay Interface and Lan Interface is not same?
interface Overlay1no ip addressshutdownotv control-group 225.0.0.1otv data-group 232.10.10.0/24otv join-inte...
Hi Stanly,
Just a big picture regarding the Cisco SD-WAN.
1 Meraki is like a cloud base which the meraki router automatically get configured via cloud and you can have a web login to control, manage and access devices.
2. iWAN is a CLI configur...
Any update on this? Did you manage to fix this issue? I am having the same issue for two sites that Dial 0 to the operator having one-way audio. The operator cannot hear anything.
offset-list work but I applied it on DC1. I read more article about eigrp metric and the outcome of changing the bandwidth delay value might be to big then it will not included in the route topology.
Config t!access-list 50 permit 10.50.110.0 0.0.0.2...
.png "Arumugam Muthaiah"){kind=avatar}