About stavropouloss

stavropouloss · 03-06-2015

I'm trying to upgrade the UCCX from 8.5(1)SU4 to 10.5(1). I've installed successfully the patch to both servers (this is a HA installation). When I'm trying ti switch versions this is the error message it returns:"ERROR: Only one entry found in /grub...

stavropouloss · 06-23-2014

Hello,I'm integrating UCM with LDAP server for directory services. I use the UDS setting by default in the jabber-config.xml. When I'm searching for a contact in Jabber I get what the screenshot shows when mouse over or when I right click and click C...

stavropouloss · 06-03-2014

Hello community.I'm setting up a telepresence solution with Expways and UCM/IMP. There would be a couple of MX300 G2 and SX20 but 100-200 Jabber clients. I'm trying to setup the traversal zone between Expway Core and Edge using TLS so I have to creat...

stavropouloss · 06-02-2014

I'm setting up a Teleconference environment (10.5 CUCM/IMP) with some MX300 G2, SX20 and many Jabber clients. The solution is the new Expressway Core/Edge.It seems that I can't manage to make the Expressway Core to connect to the Unified Communicati...

stavropouloss · 05-22-2012

Hello community,Does anyone know if it is possible to use a Tunnel interface as a source for the media resourcesregistration to UCM 7.1(5)? I know that it is not possible with vrf interfaces for example. Apparently that is the case for Tunnel interfa...

stavropouloss · 05-10-2016

Hello everyone. Since I had the same issue, what I did to fix it was to delete the IM&P server from System > Server section and add it back again when the re-installation script notified me that this was not the first node in the cluster. After that ...

stavropouloss · 05-22-2015

Actually the issue was that it took a great amount of time for the UCCX to switch versions. This worked after an hour without doing anything else. It looks like that after the switch versions command the active partition unmounted and after an hour f...

stavropouloss · 03-06-2015

Thank you for your reply. The first screenshot shows the exact version I'm running and yes it's 8.5.1.11004-25. Actually is the 'show version active" output. To be honest I wasn't watching the installation procedure all the time because it took 2+ ho...

stavropouloss · 06-23-2014

Thank you for your reply. Unfortunately I don't have access to the LDAP. This is managed by the customer organization and they have strict policy about editing OUs and make changes. The info in the fields is also used for other enterprise apps.

stavropouloss · 06-23-2014

Just to follow this up I've managed to configure this. Anyway as soon as the traversal zone is active the UCM services will also get active. For this you need certificates for the TLS negotiation of course. Additionally you need upload tomcat and xmp...

Member Since	‎05-26-2005 04:31 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	72
Total Helpful Votes Received	10

User Statistics

User Activity

UCCX switch-versions fails due to "ERROR: Only one entry found in /grub/boot/grub/grub.conf. Cannot swap grub entries."

Removing or editing contact numbers and attributes showing up in Jabber

Creating a CSR using Expressway

Expressway Core cannot connect to the UCM IM&P. XMPP router: Inactive

Media Resources (MTP, CONF, XCODE) TCP_CONN_ERROR

Hello everyone.

Actually the issue was that

Thank you for your reply. In

Thank you for your reply.

Just to follow this up I've