Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a question, so far I have only ever upgraded to the next or higher version. Now the planis to downgrade because there are connection interruptions. FYI, it is a stack of 2 3650-48PDswitches. Almost nothing is configured there except that...
Hi,I have a question about Identify a Client by name on the WLC. It is currently the case thatI only see the MAC address of the clients or under the name that it was not identified.What do I have to configure now so that I can also see the name of th...
Hello,I have a question or two about setting up a site-to-site VPN between a Meriaki MX67 and a Sophos XGS.So I have already found the point on the Meriaki Cloud page where I can activate the site-to-site VPN. However, there is no button there to man...
Hello,I currently have the following problem. In my test environmentI was able to successfully test the following AP. However, nowat the customer, this AP cannot connect to the WLC.It is an AIR-CAP1532E-E-K9. The other APs are AIR-AP3802I-E-K9.Can so...
Hello,I have the following problem, if I have to disconnect the WLC 2505 from thepower supply, it loses the time. It is then always on 01/01/2000, even thoughan NTP server is entered.Is there a way to check that the NTP server that is entered on the ...
Hi @Mark Elsen ,I think I have currently found a different way with the customer. Instead of downgradingthe switches now and then using EOL switches next year, the customer is now consideringreplacing the switches with new switches.
Hi @zillams ,does it work?I had a similar problem yesterday. The following helped:I reset the date on the WLC to a date before the certificate expired,then the AP was able to connect and then I set it back to the currentdate. The AP was then able to ...
Hello,thanks for the tip. Now I could set that. The site-to-site tunnel is also available, but unfortunately I can only reach the opposite network in one direction.Current configuration:Server HAN => Sophos => Fritzbox => Internet <= Meriaki <= Serve...
