Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
how can I allocate SIP channels on a centralized SIP trunk for foreign locations or maybe a special application.
Before the centralized SIP trunk every foreign location had a own gateway with own ISDN connections to the provider.
After the ...
Hi,
we have one installation of Expressway-C and E where the E has one single NIC with NAT enabled.
The MRA Zone from the C to the E is connected to the Public NAT IP (NAT reflection) and the Zone is working / established.
But the Zone from Exp...
Hi,
One customer is using CUCM 12.0.1 and Jabber 12.1 without IMP server installed.
How can we install the Jabber 12.1 to “Phonemode only”?
The question because due to this guide the “product_mode” should be set
https://www.cisco.com/c/en/us/...
Hi,I try to add several SIP Trunks via AXL but this "addSipTrunk" is not working.Does anybody know why this is not working?my $res = $cm->addSipTrunk( SOAP::Data->attr({xmlns => ''})->name('name'=> $name), SOAP::Data->attr({xm...
Hi,
I configured Cisco extend and connect (https://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/211427-Configure-Jabber-Extend-and-Connect-and.html).
At one customer it working without any p...
Hi Shalid,
the MRA zone of Exp-C is configured the the FQDN of Exp-E.
The FQDN of Exp-E is acutally confgured to his NAT IP (Public IP) which is described here at page 62:
https://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/vc...
Hi Jaime,
many thanks.
So that means the install parameter PRODUCT_MODE=phone_mode is not neccessary, correct?
At the enduser only "Home cluster" without "Enable User for Unified CM IM and Presence" and at the service profile no IMP servers, co...
Yes at both customers it`s CUCM.
At working customer it`s CUCM 10.5 with MGCP voicegateway.
At non working customer it`s CUCM 11.5 with H.323 voicegateway
Hi Dennis,
in our setup LAN1 is internal LAN (DMZ-internal with private IP) and LAN 2 is in DMZ-external also with a private DMZ-external IP address which is NAT-ed to an external / public IP.
BR
Michael
Hi Manish,
this I already know and there is still a manually doing to change the order of SUB1 and SUB2 in the CM Group.
So there is no automatically chance to auto-register phones in location 1 to SUB1 with a universal template from location 1 and...
