We're currently got 4 FXO ports that are PLAR'd to 7403 and when the link to callmanager is up it rings a hunt group.  We also dial 8 for an outside line. When SRST kicks in our 8841's failover fine but the translations don't seem to work for inbound and outbound digit manipulation so calls don't ring 7403/202100 and dialing 8 gives you and immediate busy signal.    Any pointers or assistance would be greatly appreciated.   Below is a section of our config: voice register global  mode srst  timeouts interdigit 4  system message SRST Mode  max-dn 25  max-pool 25 !          voice register pool  1  translation-profile incoming SRST-OUT  translation-profile outgoing 9  id network 172.XX.11.64 mask 255.255.255.192  proxy 172.XX.11.65  alias 1 7403 to 202100  dtmf-relay cisco-rtp  codec g711ulaw  no vad ! voice translation-rule 9  rule 1 /^8/ // ! voice translation-rule 30  rule 1 /7403/ /202100/   voice-port 0/0/0  connection plar 7403  caller-id enable ! voice-port 0/0/1  connection plar 7403  caller-id enable ! voice-port 0/0/2  connection plar 7403  caller-id enable ! voice-port 0/0/3  connection plar 7403  caller-id enable  ! dial-peer voice 1 pots  preference 1  destination-pattern .T  port 0/0/0 ! dial-peer voice 2 pots  preference 1  destination-pattern .T  port 0/0/1 ! dial-peer voice 3 pots  preference 1  destination-pattern .T  port 0/0/2 ! dial-peer voice 4 pots  preference 1  destination-pattern .T  port 0/0/3 ! dial-peer voice 100 voip  destination-pattern 7403  translate-outgoing calling 9  session target ipv4:10.X.0.5  dtmf-relay h245-signal h245-alphanumeric cisco-rtp  codec g711ulaw  no vad ! dial-peer voice 101 voip  preference 1  destination-pattern 7403  translate-outgoing calling 9  session target ipv4:10.Y.0.5  dtmf-relay h245-signal h245-alphanumeric cisco-rtp  codec g711ulaw  no vad ... View more