Hello,On a lot of our switches we utilize GLBP for load-balance and failover. We use Ciscoworks LMS 2.6 to monitor the network devices. The problem I seem to have is that when we use GLBP Ciscoworks complains that the interface is down and unresponsi...

Hello,I understand you can do a GRE/L2TPv3 tunnel (router to router) and get multicast through the tunnel. But is there a client based software to appliance VPN that will allow to do the same? If Cisco doesn't make one who does?

I have configured PBR on a 3660 router to route local traffic outbound to 2 different pix firewalls that sit in front of this 3660 router. I have 4 t-1 sites connected behind this 3660 router (all 2611 routers). Now the problem isn't routing throug...

I had a question possibly not unity related but so i get an Outside caller and the caller is routed to unity for the opening greeting. From there the caller knows if he dials DN 103 he will get 103. But I want to put a block on DN 100-150 from inbo...

I have setup a pix in my lab before i go live with it. I setup the outside route and the nat and it worked fine from clients on the inside accessing the internet. But when i configure the VPN and SSH connections im not routing outside from the clien...