About HARIS_HUSSAIN

HARIS_HUSSAIN · 02-19-2022

If we restore Expressway from a backup on a new Virtual Machine? Will it restore the certificates and Option key,Release key OR Do we need to regenerate the licenses and certificates?

HARIS_HUSSAIN · 04-23-2020

We are planning to upgrade UCCX from 11.5 to 11.6. Does this need license rehost? Note:- We are not going to change any other parameter this is just inplace upgrade.

HARIS_HUSSAIN · 10-05-2019

With UCCX v 12.0 Cisco Has Changed the way Reason Code is displayed in reports. Previously Codes were displayed now Description of the Code is Displayed. Till v 11 the report e.g Agent Login Logout Report was showing the Logout Reason Code which Is i...

HARIS_HUSSAIN · 04-21-2019

I have a test setup with CSR1 and CSR2 connected via the dummy Internet. as below When i Configure Tunnel mode to be GRE ip everything work I am able to ping between routers and also the tunnel interface.But if i set tunnel mode ipsec ipv4 it stops w...

HARIS_HUSSAIN · 04-16-2019

Can we setup DVIT to allow SPoke to spoke direct communication just like DMVPN mGRE tunnels allow.

HARIS_HUSSAIN · 03-22-2023

Thanks this helped. on 79XX Models the options were grayed out while on new 78XX Models options were not visible. Just enable the speaker the option will come back.

HARIS_HUSSAIN · 12-14-2019

Do we have any updated information on this now?Can Any One Help Here.I can see below video which says Key Usage must match, But that still leaves us with Question of Key Encipherment and Key Agreement..beign mutually exclusive in Microsoft CA templat...

HARIS_HUSSAIN · 10-23-2019

Dear TrickTrick,1) You one another option of using BACD Script in Voice Gateway.So if your call is coming via Voice Gateway, You just setup BACD Script in Voice Gateway to play and IVR and route call to CUCM.2) Another option is to use the Native Cal...

HARIS_HUSSAIN · 10-23-2019

I think you mean New Users or other configurations you add while the publisher is down.All the functionality will work except you cannot add new users via LDAP. When a publisher is back again it will sync the data from the subscriber like new voicema...

HARIS_HUSSAIN · 10-23-2019

1) Try to Change the Users to Local User, then add the Users via BAT. Later Resynch the LDAP the users will again become LDAP User. Try this for single users before proceeding with all.*** Please rate helpful post; Mark "Accept as a Solution" if appl...

Member Since	‎01-27-2015 11:00 PM
Date Last Visited	‎03-13-2024 12:02 AM
Posts	848
Total Helpful Votes Received	927

User Statistics

User Activity

Will Expressway Restore Operation also restore Certificates and Lic

UCCX Upgrade from 11.5 to 11.6 Needs Licnese rehost

Need Help on CUIC Standalone Report Customization

IPSEC TUNNEL SHOW ACTIVE BUT TRAFFICE NOT FLOWING

DVTI Spoke to spoke direct communicaton

Re: Hello,

Re: Certificate Extensions required for various UC certs

Re: IVR with Only CUCM (?)

Re: Unity connection publisher move from one DC to another

Re: Modifying Default Credential Policy Credentials