I need to configure a method similar to Forced Authorization Codes (FAC) on CME 12.6. The CME 12.6 Compatibility Guide indicates that FAC for SIP is not supported.How do I go about configuring TCL Scripts that would provide support in a similar manne...
PSTN Users can call into Unity Connection Auto Attendant and leave a Voice Message by choosing Option 2 and Option 3.Both options are configured to transfer Call to Unity Connection Voicemail Box. When the CDR is reviewed it shows two Call Legs:Leg 1...
Recently upgraded 6941 ip phones for a client from SCCP69xx.9-2-1-0 to SCCP69xx.9-4-1-3SR3. The time is now several hours ahead. No changes have been made to CUCM or NTP Servers. Has anyone ever experienced and taken steps to fix this issue.
In order to recovery the switch, I have to use the xmodem protocol to upload the ios image to flash as opposed to tftp via the Ethernet Ports. What could be the reason why the ports are not functioning in Rommon Mode ?
Hi Kumar,
The NTP Associations seem to be fine, the firmware utilized before upgrade was SCCP69xx.9-2-1-0, didn't have any problem with time synchronization. Only when firmware was upgraded this issue occurred.
So, what your saying is that I'll have to utilize the console cable to do an ios upload and manipulate the (baud rate) transfer speed. Because the boot loader does not have the ability to activate the Ethernet Ports
