Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Friends I require to Implement Validation of 3 attempts, in option 2 of the IVR of automatic attention service.After the client enters the data incorrectly 3 times, the call should no longer go to an agent, the audio "Please check the data and call u...
Good afternoon, I am relatively new to this area and I have to do some tasks with a script.Could you help me by telling me how to create a new option in the IVR, in this case option 0, and how do I configure that option to redirect to an extension?
Good afternoon colleagues, a few days ago I updated my cucm to version 12.5 u3, part of the requirement of the tasks that I had to perform after that was to activate mix mode, which I did according to the documentation. The CTL certificate was create...
Estoy estudiando para el ccnp core y encuentro este tema el cual no logro entender el funcionamiento y los usos practicos del mismo, alguien con el conocimiento y experiencia en casos de uso me puede dar una mano con esto? --------------------------...
Good morning companions.I have configured call pickup, it works without problems, however in the Jabber mobile application I do not receive notifications of incoming calls to my Pickup group. Notifications in the phone application are activated, howe...
Hello, I followed the guide, downloaded the file and loaded it into the call manager, when I went to the option of show software the file appears active. After that I restarted the call manager, however everything remains the same.Is there something ...
Hello, I followed the guide, downloaded the file and loaded it into the call manager, when I went to the option of show software the file appears active. After that I restarted the call manager, however everything remains the same.Is there something ...
@Daniel Ordóñez Flores ha escrito:
Hola esneyder_an16@hotmail.com
A traves de la consola escribe la siguiente linea de comando
debug client <mac_del_cliente>
Y compartenos el output del comando.
Una duda ambas redes utilizan el mismo método de seg...
Cuando ingresé el comando, y traté de conectar ese usuario al SSID no mostró nada y no se conectó, sin embargo cuando lo conecte a otro si.
(Cisco Controller) >debug client EE-2C-88-68-D7-1E
(Cisco Controller) >*apfMsConnTask_5: Aug 29 14:35:24.477...
