Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My EoMPLS stopped working after one ge-wan interface gone down and up.Before the down it was working fine.The connection is between two 6500 switches, trough GE-WAN (OSM+4GEWAN) ports.One swith have IOS 12.2(18)SXF6 and the other is using 12.2(18)SXE...
I have a q-in-q port in a 6509 with 12.2(18)SXF6 with this configuration interface GigabitEthernet3/48 description QinQ Vlan 4001 switchport switchport access vlan 4001 switchport mode dot1q-tunnel mtu 9216 And when I do an show interface, I have too...
I have two 6500 switches connected directed trough a fiber link.I am using Ge-WAN ports, so and OSM module.When I configure BFD withbfd interval 50 min_rx 50 multiplier 3Sometimes I have an down in bfd and 1ms after I have the up.But If I configurebf...
I have a q-in-q port with this configurationinterface GigabitEthernet3/48 description QinQ Vlan 4001 switchport switchport access vlan 4001 switchport mode dot1q-tunnel mtu 9216And when I do an show interface, I have too many giants!!!See:show interf...
I have an PFC3B and the BPDU are not getting trough my EoMPLS or VPLS.And How can I disable the spanning-tree for a vlan?I tried "no spanning-tree vlan X" but vlan X still have spanning-tree.I am using MST.
This answers is for 3750Metro- Which CoS value is set in the outer VLAN tag? The switch copy the inner cos- Which VLAN tag does 'mls qos trust cos' trust? The outer tag- Would the CoS value of the inner VLAN tag be inherited/passed to the outer VLAN ...
