Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Recently I've failed to upgrade the newest version of IOS for my stacked 3750 switches (only 2 units).I've successfully upload the .tar image on the switches and then extract to both of the switches. Before reloading the switches, I change the boo...
Hi guys,Need some advise from you.My site have a MPLS connection with a CoS service-policy output configure on it. The problem is, my link keep on congested by incoming default traffic! How do I stop this? My business class CoS is base on IP range, d...
Hi guys,I've a situation where my VOIP and DATA on a different segments. Voice is 10.x.x.x riding on VLAN 701. And my data is 192.x.x.x riding on VLAN 100.The problem occur when our receptionist PC have a software installed for call forwarding for ou...
Hi guys,I've a situation where my VOIP and DATA on a different segments. Voice is 10.x.x.x riding on VLAN 701. And my data is 192.x.x.x riding on VLAN 100.The problem occur when our receptionist PC have a software installed for call forwarding for ou...
Hi guys,I've a situation where my VOIP and DATA on a different segments. Voice is 10.x.x.x riding on VLAN 701. And my data is 192.x.x.x riding on VLAN 100. The problem occur when our receptionist PC have a software installed for call forwarding for o...
Hi,Thanks. I've already solved it by not putting the pc on neither vlan 701 or 100. The pc is getting the DHCP IP and able to ping the PABX IP as well. Problem solved! Thanks.
Dear Satish,I've already check and done what you tell me to do.But unfortunately debugging at the HQ Cisco router doesn't come out with any messages ( I've already turn on Ter Mon and apply command debug isdn q931 & debug isdn events )Regards,Azmir.
Hi, How to know its clean fr slips?Here is my show controller e1 outcome :-E1 1/0 is up. Applique type is Channelized E1 - balanced No alarms detected. alarm-trigger is not set Version info Firmware: 20060623, FPGA: 20, spm_count = 0 Framing is ...
Hi Mohammed, thanks for your answers. I've a Cisco 1751 with Flash of 16M, can I upgrade it to 32M? And also, for the 1750, I can't upgrade it to Flash 32M & RAM 64M ??Thanks.
