Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As we known, MCU is already End-of-Sale. We're trying to sale CMS to our customers. As what the customers requested mostly, CMS doesn't support customized layout like MCU does, but CMS support more participants than MCU.
Anyone can point out all the ...
Hi guys,
I have a third-party PBX connected to a brand new 2921 with 4FXO. All the phones are registered to this PBX.
When I called the phone on the branches, I was supposed to dial "10", (wait till the call transfer from pbx to voip gateway ) and th...
Environment：
CUCM 10.5
CUPS 10.5
Jabber for windows 11.x
The screen capture and file transfer option is grey out in Jabber chat window.
I have already added the following into jabber-config.xml file
<File_Transfer_Enabled>true</File_Transfer_Enabl...
When I tried to telnet from a ASR router, it showed as the following:router#telnet w.x.y.z% Out of local portsThe ASR router is able to telnet in the past, but it failed since a reboot recently.Any suggestion to solve this problem?
I was planning to install a virtual wireless LAN controller on a physical machine.But I failed to install when i enter the “bash” mode look like a linux user-interface. I wanna know if vwlc has to be installed based on vmware environment?even if I us...
As what the im&p document said, the file transfer option should be enabled in cisco xcp router section from service parameters in IM&P. But I didn't see it on the webpage.
And after the jabber-config.xml uploaded, I tried to reset jabber and login ag...
Does those 4 services is nessesary for file transfer and screen capture?
I have already uploaded the xml file to the root directory on CUCM as a tftp server and restarted the tftp service.
Hi Peter, The router is running NAT. And sometimes it showed NAT entries are overload. The following is the output of show ip nat statistics. And the command show control-plane host open-ports is not supported on this router.#sh ip nat statTotal act...
Thank you for ur kindness. After what u said, the following is my solution.Configuration -> IPS -> Sensor Management -> Sensor Healthno tick the box of “Event Retreval”
