About elliottbujan

elliottbujan · 09-14-2005

I need to install an ip phone at a warehouse loading dock that's about 120m away from my 3560 switch (PoE).To start with, the contractor tells me that a lift is needed to run the wiring over the warehouse ceiling. My biggest issue is of course the d...

elliottbujan · 08-17-2005

A few of my users complained that some of their messages had a very loud screetchy noise at the end of it; after 10s or so a busy signal that would play almost forever; I stopped the thing at over 2mn! and never got the options for the message.Anyon...

elliottbujan · 07-22-2005

My corporate office have 4x 7960 that have our main incoming lines. All of them have the same dids; except for the user's own extension, they're all configured the same way. When someone calls, they all ring at the same time.Being a novice with adv...

elliottbujan · 04-01-2005

I just did an branch install of several phones and I thought it was going to be another relatively easy one (and I laughed!) One issue that I found was that I can't reboot the phones with **#** Is that a feature that can be changed? does it depend ...

elliottbujan · 12-21-2004

At our branches we designated an extension for an autoattendant (w/voicemail) that would ring on specific 7960s, usually at the reception desk and the office manager. We can have 1 or more employees with 7960 configured to answer the main line.These...

elliottbujan · 12-12-2005

We install a paging system mainly for our warehouses using the following equip.:1 ata-1861 Valcom paging controlx paging horns w/volume controls and powered by a Valcom power adapter.This works very good. The ata is configured with a DN (cti route p...

elliottbujan · 11-30-2005

We upgraded from 3.3(3) to 4.1(3)sr2 on friday and today voicemail started to take breaks.the pauses are between prompts and the ones you have mentioned, hello... please enter your password..., etc.the message itself runs ok.Did you guys find a fix?

elliottbujan · 07-22-2005

I guess I need to do some homework because I only have 1 pilot point, 94000. The hunt group is blank across the board for the 94000 pilot point. I need to read more bout pilot points. I don't know how to setup them up. But it seems this is the ro...

elliottbujan · 07-22-2005

Chrisit sounds like we already have that.Phone 1 own's DN is 99235 and our main numbers come in as 99000, 99001...90004. So like I said if a call comes in, DN 99000 rings not 99235, forwardBusy transfers to 99001 and forwardNoAnswer to voicemail. F...

elliottbujan · 11-06-2003

Thanks Glen.I knew that ping has a low priority in traffic but I didn't think that these ping times could be this high.I did ping other devices as well on the LAN and across the WAN and they came up fine (my normal ping times are around 30-40ms). My...

Member Since	‎11-13-2001 04:46 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	22

User Statistics

User Activity

I need to install an IP phone, 120m away from m switch - How?

Screetchy noise at the end of voicemail

Autoattendant roll-over

IP phones won't reboot w/ #

Cannot access voicemail

Re: Overhead Paging with Callmanager

Re: Unity Slow Message Retrieval

Re: Autoattendant roll-over

Re: Autoattendant roll-over

Re: eth -> ser interfaces ping times too high