Hello,
I have a strange situation which has been boggling my mind for days. I setup a hunt pilot in CM, added my extension to it, and made some test calls from another internal DN. Everything works fine. I ran a CDR hunt pilot detail report, and...
Hello,
We have an ISR4331 with a PVDM4-128 on the motherboard. I'm new to the voice world, and have been tasked with finding out of the current PVDM4-128 is sufficient if we upgrade the total number of SIP paths we have with our provider. I inherit...
Hello,
Our Unity Connection server polls our AD server daily and creates new accounts. We have three different Unified Messaging Services created. When new users are imported, they unfortunately get automatically assigned the service that we use ...
I'm hoping some can critique a very basic redundant ASA configuration. Currently, we have rackspace at our provider. The provider provides us two uplinks to their cores. I have one ASA5520 and one 3560 switch, so both uplinks (fiber) are on the same ...
I'm hoping some can critique a very basic redundant ASA configuration. Currently, we have rackspace at our provider. The provider provides us two uplinks to their cores. I have one ASA5520 and one 3560 switch, so both uplinks (fiber) are on the sa...
Will,
Good thought. I wondered about that parameter myself. Unfortunately, no change. I did change the parameter on both the pub and sub. Not sure if I needed to restart anything for that to take effect, but if so, I need to plan ahead for that...
Hi Nipun,
I checked the regions and device pools. All (but one) are set to the default:
DefaultUse System Default (Factory Default low loss)64 kbps (G.722, G.711)384 kbps2147483647 kbps
There is one entry:
G729 EverywhereUse System Default (Fa...
Thanks, Chris. Interesting. OK. I will try to get a downtime/change-window to do this today. Just for my own knowledge (and others who may be in the same boat), how do you know these are un-needed codecs? Are they legacy and not in use anymore? ...
It's in one of the posts above, along with my theorizing that the max value had to do with defined codecs in the farm, but here it is again:
!dspfarm profile 2 transcode codec g729r8 codec g711ulaw codec g711alaw codec g729ar8 codec g729abr8 maximu...