Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day,i still have this problem/bug on a 4331, although it should be fixed in these versions :Fuji-16.9.5Gibraltar-16.12.3Amsterdam-17.2.1r ccsip_call_setup_request: Call destination is same as registrar.sipSPIGetCachedRegistrarAddress: CUBE not r...
Hi,we have a 2821 with ios 14.4XC1We have 2 7970 that I would like to locale to german languageI found this article:http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00805d9a12.html#wp1022822Is it true th...
Hi,we have a 2821 with a nm-cue. Due to a power-cycle without shutdown of the device, it will not start-up again.After a reload or reset command the status comes up as failed after some minutes!Is it possible to repair by myself, or do i have to send...
Hi, I have several 7960G with User License, but I am unable to include them to the Smart License Account. The phones came without PAK, only Serial and Special number, so I can not do the traditional licensing and convert them into smart licenses. Onl...
Regarding this bug: CSCvr90926 It should be resolved in 16.9.5 and 16.12.3 I tried both images but still getting the same error when dialing out:%VOICE_IEC-3-GW: CCAPI: Internal Error (Resource busy): IEC=1.1.181.1.25.114 on callID ............ Does...
Hi,I have attached two working configuratons. Not sure what you already included in your full configuration, but I guess that you already implemented the Telekom root certificate.Not sure if you have an ISR-G2 or a ISR4K. Attached are both configs. M...
Hi,please make sure to create new phone files after you made any changes:conf ttelephony-servicecreate cnf Also, make sure to have a dhcp server enabled to provide an ip-address to the phones: ip dhcp excluded-address 192.168.100.1 192.168.100.50!ip ...
Hi, I had the same problem with all 8800 sip phones, and no SCCP Phone. You have to add to your config: telephony-service codec g722-64 service phone g722CodecSupport 2 This is required even with no sccp phone used. Hope this helps Marc
