Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!
I´m facing kind of a complex situation and came here to ask you guys for advice.
Here is the situation:
New CUCM deployment using centralized architecture; CUCM cluster is in HQ and there are branches distributed in a geographical space.
...
Hello
Do somebody has a chart or a matrix for cisco voice routers disconnect codes?
when I use "debug voice ccapi inout" sometimes I face with some error codes like:
*Jun 26 20:34:27.349: //10337/24130DCD8FEF/CCAPI/ccCallDisconnect: Cause Value...
Hello
Do somebody know by experience or by some official source what is the firmware maker of all cisco-tandberg telepresence endpoints?
There are different series of telepresence endpoints like:
DX IXCETC
EX
SX
CTS
etc.
I´m about to take 210-0...
Hello
Somebody knows if it is possible to configure IM&Presence 11.5 to enable supervisors chat to agents but disable chat between agents using Jabber?
If so, is there any guide to do that?
Thanks
Hello
Somebody knows how to set CUCM 11.x GUI language to english again after installing a locale?
Locale is istalled to play prompts to customers in their native language, also to set phone´s menu to their language but as CUCM admin I´m not confort...
Hi KitaThank you for your comment I haven´t tried your approach but I think it may work.After thinking about it a little bit and asking some co workers I decided to use MGCP to control those FXO ports from CUCM. I´ve seen this worked before but I d...
In case anyone else need it here is the ITU Q.850 standard for with complete list of cause codes (from 1 to 127 error codes) , pages 10-16, Table 1/Q.850 – Cause information element/parameter
https://www.itu.int/rec/dologin_pub.asp?lang=e&id=T-REC-...
Hi Jaime
It seems amazing how PCD can do the job but I have a question, does PCD need some kind of license to do that? or is like COBRAS that doesn´t need a license?
Thanks
Hi Jaime
It seems amazing how PCD can do the job but I have a question, does PCD need some kind of license to do that? or is like COBRAS that doesn´t need a license?
Thanks
Hello Wayne
Thanks for your response.
You are right on that.
But I think I didn´t explain myself.What I meant was how to know what devices have what firmware:i.e. As far as I understand SX endpoints have tandberg firmware, so you know their CLI use...
