Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We're in the beginning stages of converting the client's wireless environment from separate controllers at each site to a centralized controller with flexconnect.We'll be using ISE for 802.1x authentication as well as Guest access. Each site will ha...
We are using Centralized controllers with flexconnect access points. Requirement came from client that guest users be able put on a VLAN that is not routable internally yet we want them to authenticate against ISE and get a AUP splash page before get...
My client has a Bogen pager connected to an FXS port with the nighbell extensoin configured on it. When you dial the extension it rings the overhead paging and someone has to pickup that call using group pickup. The only way I can see this working is...
I though I'd ask before I open a TAC case. Newly deployed stack of 6 3850 switches as core. The top three are 24xs all SFP.
there are about 22 access switches (older models) that are uplinked via fiber to the core. I could see all through CDP, but th...
I'm trying to Deploy new 2802i Access points. Supposedly they are LAG capable when plugging in both POE and AUX ports and can detect LACP etherchannels. They are connected to a 3650 POE+ switch.
For some reason they won't come up if I configure Ethe...
I know 80 nodes is overkill but they're looking for maximum resiliency and making sure each site can still authenticate clients even when their SDWAN is down. Ofcourse Cisco will not object to selling so many!I think I've resolved myself to this bein...
Thank youI actually just tried this now and that worked. The secondary auth policy was just permit access, and the assumption was it would go to the assigned vlan in the flex connect group.Instead I created a new profile that assigned the guest the v...
yes I set the lease time to one minute. It just keeps renewing in the same vlan.I don’t know if the flexconnect setup might be messing it up. In the flex connect group I have the SSID going to the Guest VLAN. But in order to put it in the temporary v...
