09-13-2009 07:57 PM - edited 03-21-2019 01:30 AM
I am trying to get the multi-level AA working on my UC 500
I have a base AA at ext 298
I configure option 3 to send to submenu1
This submenu appears to be created as 2981
But when you call 298 opt 3 you get dead air for about 10 seconds then disconnects
Never plays prompt, pressing keys do not yield desired results etc.
Any ideas?
This is my first UC, so maybe I am just lost.
09-17-2009 09:30 AM
I ran a case through TAC, they were able to reproduce the issue and have deemed it an issue with CCA. Issue is with both 2.0.1 and 2.1
We have worked out a work-around but it is outside of CCA.
09-14-2009 06:04 AM
Did you configure a prompt for the option? Is it enabled?
09-14-2009 06:33 AM
Yes I created a prompt, but not sure how to "enable" it beyond having the first level AA call it.
Please clarify
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide