Smart Call Connector Advanced

[jakins12]

Am working with the Smart call connector product and have a few questions.

I am finding that the clients are looking for voiceview using the ip address of the data segment instead of the Voice segment.  I assume the SCC server is giving that url to the clients. But am not seeing where it is defined.

It was my understanding that this product interfaced with SNR, but am not seeing where this ties.  Am I missing something here?

[Alberto Montilla]

Dear sir;

I've routed your first question to our SCC team, they will reply directly.

With regards of the second question. SNR is now an embedded feature of the UC500 and configurable via CCA, no longer available on the call connector. Please let me know if you are looking for something not available on the system.

Regards
Alberto

[Steven Holl]

SCC 1.6 does not have SNR capabilties yet.  If you require UCC SNR, you need to run UCC 1.5.  UCC 1.5 does not have operator console functionality, though.  Essentially you will have to pick one, or the other.

You could use the built in CME SNR functionality (which isn't as flexible ass UCC SNR) with SCC 1.6.

Regarding the voiceview URL, I'm not sure how the console pulls that down since I haven't used voiceview with SCC yet.  With the phones, it is done via the service URL defined in telephony-service; make sure that is defined with the CME IP address and that voiceview is working for IP phones.  Do you have CME added in SCC with the CME IP address, or with the data VLAN address?  If it is pulling locally, that's where I'd assume it would pull from.

-Steve

[nyciscotech]

Will we see advanced SNR capabilities brought to SCC in the future?   The SNR set built into CME offers limited functionailty...

[Steven Holl]

SCC 2.0 will have this capability, and it is currently in beta.

[shtalukd]

Hi

The CUE IP Address is defined in section and page where the UC500 information is specified. This is the page from which the router information is downloaded. Please see attached image.

The SNR functionality is not included in version 2.0. We are planning for its inclusion in a later release.

Thanks

SCC Team