VPN

Hello, I have dmvpn with hub and spoke topology. I route all traffic from spoke to HUB. So i have phsyical wan interface in vrf internet, point tunnel interface source vrf Internet, and have default route in that vrf internet. When i test speed it is...

I am a Purdue student using Purdue's Cisco AnyConnect VPN. After I click "connect" and enter my password and make sure Duo Mobile approves, it connects, but only for 6 seconds before it says "optimization" and disconnects. This issue is sudden, it ha...

Hi Folks, I need Urgent help. I am trying to configure ikev2 tunnel between two CISCO Routers. However, the problem is that my router is behind a firewall and not able to properly route traffic to the other router. However, when i connect straight to...

Hello, We previously had an IKEv1 VPN tunnel between a FTD 1140 and two ISR4431 routers, where we use the second routers IP address as a backup in the crypto map. We recently changed those tunnels from IKEv1 to IKEv2, but we have issues with the back...

When you setup a policy-based Site-to-Site VPN Tunnel with ASA/FTD on oneside or both, the firewall would automatically inject a V route of the remote prefix into the routing table. If this tunnel is up, traffic flows as expected. But if the tunnel i...

Hello,We are using Cisco Secure Access (SSE) with Advantage license. Our default gateway is 4d8c.vpn.sse.cisco.com, and we have created a CNAME vpn.company.com pointing to it.We would like to upload and bind a custom SSL certificate for vpn.company.c...

New to Cisco and anyconnect. I have created a anyconnect profile and after users is beginning to use the profile users are getting is error "Connection attemt has failed". I have only entered one server in the Serverlist.

I am trying to create a VPN connection to a Sonicwall running gen 7 os.  We already have two VPNs from the same Cisco to two other clients running gen 7 Sonicwalls.  I copied all of the settings and the Sonicwall shows connected with the green dot bu...

pretty sure this isn't a unique case but I can't seem to find a viable solution.  TL;DR - we replaced our old vpn solution with a Meraki mx67 and our linux users cannot use anyconnect due to constant reconnectsnow the long version - Some of our end u...

Hi All, I have done IPSEC setup as below(Link) where one end ASA has public IP and the remote end is dynamic and ASA is behind a NAT.  Configure ASA-to-ASA Dynamic-to-Static IKEv1/IPsec - Cisco Currently, the Hub CISCO ASA accepts IPSEC tunnel from a...

I hope that someone can clarify this to me. a site to site was configured properly without any problem . A NAT was required to change the source address, the destination is unique to the site(NO NAT) . the vpn was up but there was no traffic going ...