Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks,
I need Urgent help. I am trying to configure ikev2 tunnel between two CISCO Routers. However, the problem is that my router is behind a firewall and not able to properly route traffic to the other router. However, when i connect straight to...
Hi All,I have a scenario that i have tried dealing with with but out of reach. This is my situation: I manage an autonomous system-HQ with different physical branches with their own subnet with its own DNS/DHCP. So that means each site has its own vl...
Hi All,I need assistance to login using my FDM GUI. Output below are on waiting state. I can access firewall through CLI. Refer screenshot of the login page with error. root@rg-firepower-fw:/home/admin# pmtool status | grep -i waitingTSS_Daemon (norm...
Hi All,I need assistance;I have a 11.5 su3 CUCM and UCCX 12.0. I have configured UCCX all internal trigger is working. cti port registered.I also have an ISDN PRI with 100 number range. the current setup is that the first number range is translated t...
hi, Greetings.I have a request here. I have a vlan that has wired users and wifi users. However, i would like to use a separate vlan for wi-fi users. Can you assist me how to do that?
I have not done much natting on the router except the ip nat outside on the interface facing ISP and inside on the internal lan. Then i did the overload int LAN internet access. And also the ACL for the VPN. Find them below. thats all.
interface Gig...
Below is the config on the router interface facing the ISP:
interface GigabitEthernet0/0/1description Internetip address 203.83.*.* 255.255.255.252ip nat outsidenegotiation autocrypto map crymapend
