VPN

Hello,We are using check point VPN client in our LAN , previously ever thing was working fine but now as we have implemented PIX firewall in our LAN we are unable to connect the Check point Policy server .If any one also faced similar problem than pl...

reading on the net http://www.oissg.org/content/view/116/63/ about possible SHA1 demise due to Chinese University research paper showing a crack of the SHA1 code?Is the PIX 501 3DES/AES VPN/SSH/SSL version vulnerable to this problem?

Hi I have a vpn lan to land tunnel between PIX A and B, then I have vpn users connected to PIX A with the cisco VPN client, and whant them to be able to access the network behind pix B, I am not getting this to work, no traffic from the vpn users is ...

Hii have trouble with the static routes in pix 505, i need reach some networks for a router conected in the same segment that inside interface so i added this static routes in pixroute inside 10.65.0.0 255.255.0.0 10.72.0.1 1route inside 10.68.0.0 25...

HiSo i'm troubleshooting a vpn problem between a pix and an ios router...this is just one of many i've configured by the book and not one problem untill now. I get the following debug message on the pix;VPN Peer:ISAKMP: Peer Info for xxx.8.167.63/50...

Can some one let me know the advantage of using CA for Cisco VPN clients to connect to the corporate network. I am planning to implement microsoft CA with cisco pix firewall and make the clients connect through the CA.Thanks in Advance

Hi there, My friend has a 1604 router and is trying to access his corp VPN using the Cisco 3000 VPN client v 3.6.3.He was previously using an ISDN card on a gateway PC (instead of the 1604) and the VPN client worked fine. He has not made any changes ...

Has anyone seen a good doc so I can get a base ref to configure this to work?I have it working, mostly ;-) The tunnel comes up and the user auths with the LDAP server ok and everything looks great. Then for no reason the session terminates. Log sugg...

I've been able to connect my remote VPN clients v4.6.01 to my PIX515ER v6.3(4) but ran into the following problems and was hoping that someone will be able to help out:1. I can't ping from VPN clients into the internal network BUT I can do stuff like...

Once a VPN tunnel is established to the concentrator, clients can ping/telnet/hack! the other clients connected to the same concentrator, using the secure tunnel.I'm using the CiscoVPN client, so I figured I could push policy settings to the integrat...

I need to translate destination IP , of packetsgoing in from outside interface to Inside interface,Part of the outside world are working with Host APart of the outside world are working with Host Band we need to direct them to Host A .Any ideas how t...

I am using a PIX 515 to terminate tunnels. I have added the4 port ethernet card to the PIX and I terminate one tunnel on interface ethernet 5 using a static crypto map. The tunnel works fine and I can access devices inside the PIX. Applications wo...

I have a VPN 3005. Users either use the webvpn client or the cisco software client to vpn into our local lan. I on the webvpn home page I have added a link to an internal web server that is running a site that was written in .net and uses java and ...

HiI wish to set up a hub and spoke WAN using IOS to IOS 256 bit AES. All IP traffic to be encrypted. Can anyone point me to a guide to configuring? I have seen point to point config but nothing that shows how a hub would be configured.ThanksIan

I would like to know the best way to allow a whole range of addresses with one statement.example allow tcp from 36.1.0.0/16 to 99.99.99.16 port 25