VPN

I have a site to site VPN between a PIX 506e and PIX 501 with VPN Dialer access to the 506E setup. Every so often (ever hour or so) I have to restart the PIX 501 because it looses the Connection. The ISAKMP status goes from QM_IDLE to SA_MM_SETUP. ...

Can anyone explain me how to configure tunnel innterface for l2tpv3 for MPLS VPN.

Hi,i have the following schema:LocalA -----> LocalB -------> LocalCVPN3005 CISCO836 CISCO836All are connected by IPSEC VPN. I can't reach from LocalA to LocalC. Is there possible to do that? The VPN are over DSL lines.If possible, w...

BBSM5.3 Pre-Loaded ServerI have configured the BBSM to allow wireless laptop users on the 255 vlan to access the internet. This wireless connection works fine, however when I try to hard wire the laptop directly to the same switch as BBSM and confi...

Is it possible to configure a VPN Pool for use when the local subnet uses a 10.x.x.x /8 scheme? I ask because I was under the impression you had to define a unique range that was of a similar "class" as your local subnet. With a 10.x /8, you would ...

HiI've a very strange problem with a vpn configuration.I can ping subnet 192.168.10.x from other easy vpn remote (pix501)From other pc software vpn client I can logon on VPN Server (PIX 515E) but can ping subnet 192.168.10.xCan you help me?Thank youP...

I have a router 2821 with two Internet links over "one" ethernet port. For this, I configured the interface GigabitEthernet0/1 in two subinterfaces with Vlans (interface GigabitEthernet0/1.998 and interface GigabitEthernet0/1.999). Betwen the router ...

port access

I have two 515e pix firewalls, one with FO license and one with UR. I am using the serial cable for failover. Everytime I enable failover on the primary I get the following message and it disables itself. "mate's license 2 contexts is not compatible ...

Hi,Remote access VPN configuration has done in the 1841 ISR router. Users can able to connect and they are receiving the IP Address from the defined pool. After connecting they cannot able to access the remote desktops located at US office. If they r...

Dear All,I would like to have ur solution on the following requirement.There are 40 schools of the goverment wants to remotly access their application at the center data entre.The internet for the remote site is MPLS. In each school only one division...

I have two locations that I need to connect using two pix firewalls. One location has a PIX515E [7.0(1)] and the other one has a PIX506E [6.3(5)]. I followed the Cisco examples to create a tunnel between the two sites but I'm unable to establish a ...

my customer is having around 200 sites connected to the MAIN OFFICE through MPLS. The provider is using 3550 in all their sites and the main office as well for the MPLS. Also the main office is secured only by the PIX 525UR with failover.Each site is...

I have tried everything (limited as it is) to be able to make a connection to an XP Pro system behind out router, as best as I can tell I have setup the firewall & NAT to pass TCP port 3389 to the XP system but i just can't get a connection. I can co...