VPN

I have a simple Remote Access VPN setup on a PIX506E.Cisco Secure VPN Client can establish an IPSec tunnel VPN tunnel on the outside interface of the PIX and obtain IP Address from the vpn address pool.The Remote VPN client is unable to access any re...

Does a Cisco 806 Router can act as an easy VPN Server ? Which IOS do i need ?

Just wondering if anyone has any ideas.I have an established working LAN to LAN connection from a 3000 concentrator(local) to a Cisco 2621(client site). I have no problems communicating to the client lan from the local lan.I have software VPN clients...

Is the PIX firewall supports port level interesting traffic for IPSec tunnel ? ex, "permit tcp" instead of "permit ip"Thanks,

Is it possible to set up a site to site VPN between two routers and somehow automatically load balance the VPN traffic over multiple T1 lines connecting the two routers? In other words, if one has two equal cost paths to the remote site and one appli...

I have several PC's on the same network that are connecting just fine with a Linksys router, but only 2 PC's at a time. I don't think that the Linksys Router supports NAT Traversal. I'm using nortel contivity client software with a secure ID connecti...

I have a pix 515 that I can establish a successful vpn through, and access most of my resources (exchange, file servers). One I do this, I can do most everything fine. The things that I cannot do are:1. access my pix internal interface via telnet ...

I'm running into an issue trying to VPN from my network across my PIX and to another network using a WatchGuard VPN client.Installed on my 2003 server is the WatchGuard client, and it appears to authenticate to the remote host. The problem I am havin...

Hello all,A few weeks ago AIM-VPN/EPII-PLUS appeared in addition to AIM-VPN/EPII, but I can't find a doc that describes the PLUS. Can anoybody let me know or show where can I read about it?Thanks,Martin

Hello,I have a client on the inside network and it has a IPSEC VPN client installed on it.How do I make sure that I pass the traffic through the PIX and make a connection to a Netscreen on the other side?I have a static (inside,outside) statement so ...

HiI have a Cisco PIX 515E firewall. My office users make remote VPN connections to the PIX to access resources in the office.However, though they can access all the servers in the internal LAN, they cannot connect to other VPN users that are connecte...

Our company have a VPN tunnel between two sites, Site A and Site B. Site A is the main office and is using a PIX515E U/R. Site B is using a PIX506E. Site A has a leased line connection to the internet (1MB) and Site B has an ADSL connection to the in...

I would like to know if anybody have a sample or a cisco page that teachs to how to configure a PIX Firewall with version 6.3 to make a user that want to access internal resource on inside, first need to authenticate in local data base (PIX) for pre ...

What is the purpose of the bandwidth statement on the tunnel interface in a DMVPN configuration?All of the examples are 1000. What is the effect of changing this on one of the spoke routers.I can not seem to find any answer to this on the documentio...

Hi,here another question on a certain construct with a PIX firewall.Im doing PAT with the IP-Adress of the outside Interface of the PIX to the Network behind the Inside Interface. This works fine.Additionally I´ve configured the PIX as Easy-VPN-Serve...