Hi All, Just want to know how many anyconnect Plus/Apex License do i need to buy for a FTD HA pair ? one each anyconnect License for FTD in a HA pair, or just buy one for the FTD primary ? Thanks!
Forum Posts
I have very minimal knowledge of VPN.i want to know which VPN i can setup ona Cisco ISR 4451?I believe Cisco Anyconnect is not supported? I need suggestions.
Good afternoon; I have a 4321 router and I need to be able to configure annyconnect on this device .. Do you know if it is possible to realign it?
Let's say you have a ASA firewall in between two end points (say another firewall and router) where a IPSEC tunnel is built on - basically you have an ASA that must pass IPSEC traffic.The ASA firewall must pass isakmp and esp services and just the su...
Why is there a limit of 100 Virtual Tunnel Interfaces on the ASA? I currently have a large number of policy-based site-2-site VPN connections on a 5585 that I am trying to migrate to VTI-based VPNs, but not enough VTI interfaces....
Resolved! Site 2 Site VPN Trouble
Hello all,I am having trouble getting a site to site IPSEC VPN to come up. I can't ping across and I've reviewed my configurations multiple times and I cannot seem to see any obvious errors. Any help would be much appreciated. ASA Version 8.4(5) ! ho...
hey guys, I have a lan 2 lan ipsec vpn (thur 2 ASA ), but it's not stable, it will disconnect 2 to 5 time per day randomly.as I check , it's not cause by sa / isakmp expired, and the internet network connection is good.i wondering if there any comman...
Hello all,I have an issue with configuring L2TP/IPSEC connection between ASA 5505 and Forticlient VPN.I have managed to successfully connect using native Windows 10 L2TP/IPSEC client, however, unable to perform it using Forticlient VPN. Debug output ...
HelloWe use Cisco ASA with AnyConnect. This works well.Now I want to use the feature split-tunnel for one local address. The group policy is defined and works with my AnyConnect client. But at one customer the group policy is not used. In the ASA ses...
Hi everyone, the VPN works, is Active-Up I can ping from the Branch to the HQ, but I can't do it from the HQ to the Branch.Please find attached the sh run of both Routers.
Hello i am confused in vpns protocols and i need little clarification if possible, is it safe to say that layer 3 ( network ) vpn protocols : IPsec,MPLSlayer 2 ( data ) vpn protocols : PPTP,L2TP,L2Flayer 4 ( transport ) vpn protocols : SSL/TLSlayer 7...
Hello All, We have one of our partners who upgraded their ASA firewall from the old ASA 5510 (8.2) to newer 5508 (9.1(7)23). Since then the Shrew Soft VPN client they use (ver 2.2.2) on Windows 10, does not allow people to connect and gives "negotiat...
Resolved! DMVPN Support on ASA
Do the ASA support GRE tunnels specifically for DMVPN tunnels? I read somewhere that maybe the newest ASA firmware, 9.9x-something, might support it.... do you know if Cisco has finally added this on the ASA if so, can you provide a link? thank...
Hi Cisco Security Guru, I am trying to allow remote anyconnect VPN users to access ASA via SSH/ASDM, however it fails, denied by implicit rule: VPN IP Pool: 192.168.200.0/24, Internal interface: Vlan4015: 172.16.0.1/29 <necessary config>management-...
