Hi, Is it possible to set up site-to-site VPN tunnel for IPV6 without using VTI, similiar to how IPsec tunnels are set up in IPV4 ?? If so please let me know, I am desperately in need of help
Forum Posts
Hello,I can successfully start up a vpn connection with non redundancy crypto map on interface.If I change interface crypto map setting from "crypto map VPNs" to "crypto map VPNs redundancy EXT-VIP" the phase 2 of VPN tunnel can't be established anym...
Hi - I am moving from asa5505 to 5506 and wondered that does 5506 ezvpn support ikev2? Thanks
HI we have an ASA 5510 with 8.4(7) with many working IPsec VPNS. We have one new peer we are trying to connect but when they initiate VPN we do n ot respond. I can see incoming IKE with destination UDP port 500 but SOURCE PORT is a high port eq ...
Can anyone tell me how to check VRRP uptime for particular VRRP instance ? My router module is cisco 3945 Thank you
Hi Team, I try to connect VPN user via cisco VPN client, connection profile connect successfully and prompt for username and password also. But after that I get error in VPN client. Any ideas folks????
We have Cisco ASA for remote access VPN and we have LDAP server for centralized directory server and we using onelogin OTP service (for Token auth), at this point everything working great! But now i want to create multiple groups "sale", "marketin...
Dear All, I configured the Cisco IPSec VPN from cisco gui in asa, however, i would like to know, how to check whether the vpn is up or not via gui for [particular customer. I tried Monitoring-->VPN Statistics--> Session--->Filtered By---> IPSec S...
We are looking at relocating our data center which is presenting a few interesting situations. Not all of the systems can be moved at the same time which brings up the need to extend at least one and maybe more VLANS across the data centers until a...
Community, I have a question regarding the group policies in the ASA for Anyconnect clients. How does the ASA decide which connection profile it will use for a certain VPN connection being established? For instance if I have two connection profiles...
Hi There, We have an AnyConnect remote access VPN where outside users can access the on-premise network fine. We also have a CSR 1000v setup in Azure to allow us to RDP from the on-premise network to VMs in Azure with their private IPs. However, if...
Cisco AnyConnect Client installed on Windows Clients connecting to Cisco ASA works fine 99% of the time but from time to time we have clients who can not connect. The error message is that "hostscan results exceeded configured limit" We have been inc...
Hi,We don't know what to do now. We're stucked at MM_Key_Exch. What should we check? Thanks.Regards,John
Hi all Would any one be so kind to look at my config and tell me what I am missing. I am to configure several site-to-site VPN. Since the local subnets can be overlapping, I want to use vrf-aware IPsec towards different customers. If I however try ...
Resolved! AnyConnect VPN behind NAT device
Hi all, I have a customer who would like to put an ASA (vpn_asa) behind another ASA (outside_asa) that attaches to the internet, and use the vpn_asa to offload VPN connections. There are architectural reasons they want to do so, which we're talking...
