Wireless - Small Business

We have one of these devices (WAP 200) and in the wireless connection control panel (MAC Filter) there are only 16 available slots.  Is this the Maximum allowable or is there a way to add more?

I am looking for some testimonials or white papers on the WAP 4410N, specifically for the medical industry.  Any testimonials would help especially since it appears the abundance of such is rare. However, a link to the medical industry would be espec...

I need some help setting up a WAP4410n v 2.0.1.0 as a repeater. Warning, this is the first time I have worked with a repeater. I have tested with a netgear router and a Linksys 160n router. Unfortunately I only have the netgear to continue testing wi...

I have the following equipment:Cisco 871W router2x WAP 4410N APs running 2.0.3.3I currently have 1 AP connected to the router via copper.  The AP to AP link is over 802.11.  I have attached a diagram reflecting the current topology.The AP-to-AP link ...

Hi!We have two WAP2000 Wireless devices. One device is in AP with repeater mode and the other is only repeater. I have setup repeater settings and it does work somehow. Problem is that when I power on repeater device it will cause huge lag to network...

Hello,Currently I have a WAP4410N setup and would like to add a second WAP4410N but as wireless repeater. I want my users to have wireless access without the need to keep changing the wireless connection based on their location within the factory. Th...

Dear All     i'm having WAG320N Linksys by Cisco , connected & working properlyi need to connect 2 WAP4410 N to the router through wireless ( not wired )i've did the same SSIDsame securitysame everythingtried all the possible settingsbut it's not wor...

We have 3 AP541N units deployed in a doctors office.  All of them are set to 802.11b/g/n mode.  2 of these units are used to provide non-secured internet access to patients and are using channel 7.  The other AP is for our private network secured usi...

Hello,after rebooting our AP541Ns the manually entered time settings are beeing resetted to the default values:  01/01/2009  -  01:00.is this a known issue, because NTP is actually not an option for us.we also installed the current firmeware, and we ...

Dear  Support Small Buiness Wirelessinformation customer User use wireless about 33 user size room 11mx11m I attach design this The customer want wireless WAP4410N but have question following ?1. Can feature Loadbalance AP  ? ( Please sent configuare...

Dear  Support Small Buiness Wirelessinformation customer User use wireless about 33 user size room 11mx11m I attach design this The customer want wireless WAP4410N but have question following ?1. Can feature Loadbalance AP  ? ( Please sent configuare...

Just purchased 2 CISCO WRVS 4400N routers. Installed one at office and one at home. Was disappointed with home speed. I gained nothing over previous router, so I thought. I have a 50 Mbps connection and was experiencing a 50% lost prior to switching ...

I currently have two 541N access-points slightly overlapping eaching other and my clients appear to connect to the further AP most often.  They are setup in a cluster, but that appears to just provide configuration synchronization.  Short of purchasi...

Hi all, I’m planning to use Cisco 4410N AP for my new office. I have 20 offices in 1st floor (20 * 15 FT floor size). I want to know is it possible to cover the entire floor using one 4410N AP?How is the network signal strength?Please advice to me....

I have 2 AP541N units clustered.  When I view Wireless Neighborhood I see our speed listed at 32MBPS on 1 unit and 34MBPS on the other.  Do I have a setting wrong somewhere? What's the best way to increase our speed?