cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
717
Views
0
Helpful
1
Replies

3850 switch and 3702 WAP's

Mark Jensen
Level 1
Level 1

Hello all, I am looking at adding a bunch of the 3702s to the network. I am upgradeing the 5508 WLCs to FUS 1.7 and 1.9 then I will upgrade to IOS 7.6.110  for this. I am in need of configuration guide for the 3850 piece. Will I be able to get the full 11ac this way?  thanks for any help you can offer.

1 Accepted Solution

Accepted Solutions

Hi

In your scenario (registering 3702 on to 5508) there is no special config required on 3850, just leave it as L2 switch & configure the AP connected switch port as "access ports". I would encourage you to go for 7.6MR3 (will be released for public in coming weeks), you can get the pre-release from TAC. Refer the following link for that.

https://supportforums.cisco.com/document/12245186/76mr3-beta-availability

 

Specific configurations required if you want to enable WLC functionality of your 3850 & register your APs to 3850 WLC. Here is what you want in that scenario.

http://mrncciew.com/2013/09/29/getting-started-with-3850/

 

HTH

Rasika

**** Pls rate all useful responses ****

View solution in original post

1 Reply 1

Hi

In your scenario (registering 3702 on to 5508) there is no special config required on 3850, just leave it as L2 switch & configure the AP connected switch port as "access ports". I would encourage you to go for 7.6MR3 (will be released for public in coming weeks), you can get the pre-release from TAC. Refer the following link for that.

https://supportforums.cisco.com/document/12245186/76mr3-beta-availability

 

Specific configurations required if you want to enable WLC functionality of your 3850 & register your APs to 3850 WLC. Here is what you want in that scenario.

http://mrncciew.com/2013/09/29/getting-started-with-3850/

 

HTH

Rasika

**** Pls rate all useful responses ****

Review Cisco Networking for a $25 gift card