03-06-2017 11:36 AM - edited 07-05-2021 06:39 AM
What is the default password for AP1702i access point?
Solved! Go to Solution.
03-06-2017 02:18 PM
Alright, then just reset them to factory config and they will have the default password "Cisco"
Hope this helps,
-AL
03-07-2017 07:44 AM
Nusret,
This should get you back to the defaults:
https://popravak.wordpress.com/2014/08/26/resetting-cisco-capwaplwap-access-point-to-factory-defaults/
Regards,
Sam
03-06-2017 12:03 PM
Did you try Cisco/Cisco as username/password ?
-AL
03-06-2017 12:09 PM
Al,
That didn't work. Any idea what it takes to reset it to the factory defaults?
03-06-2017 12:11 PM
It should be Cisco.
Are you sure it is a factory AP ?
AL
03-06-2017 12:25 PM
our customer bought a few months ago a couple of these. Not sure if they configured previously or not but today they want to give them a try.
Not sure if I answered your question of "factory AP"...
03-06-2017 02:18 PM
Alright, then just reset them to factory config and they will have the default password "Cisco"
Hope this helps,
-AL
03-07-2017 07:44 AM
Nusret,
This should get you back to the defaults:
https://popravak.wordpress.com/2014/08/26/resetting-cisco-capwaplwap-access-point-to-factory-defaults/
Regards,
Sam
03-07-2017 08:45 AM
Thank you Sam and AL
05-06-2019 05:12 AM - edited 05-06-2019 05:13 AM
I had converted an LWAPP to an autonomous AP. I was then able to telnet into the AP. I thought the username and password would stay the same, but it resets to the default. I was glad to come across this info. The telnet username and password was Cisco after the conversion. Thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: