03-12-2019 07:48 AM - edited 07-05-2021 10:02 AM
I have an AP on my controller (3700i Aironet AP) lightweight showing its operational status as down.
Further checks revealed the following as seen in the attached images;
How do I enable the dot11 radio on the AP?
03-12-2019 01:07 PM
Hi
On the WLC, go to the WIRELESS tab, select the 2.4 Ghz Radios. Find the referred AP and on the right hand side, on the blue triangle go to configure and enable the radio.
Keep in mind that, radio 2.4 ghz disabled often is required by design. Make sure this is not the case.
-If I helped you somehow, please, rate it as useful.-
03-12-2019 03:24 PM
WLC > Wireless TAB >802.11b
find the AP and enable the radio
Make sure it wasn't disabled manually for a reason first. 2.4GHz is also quite often disabled to reduce co channel interference
03-13-2019 06:35 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide