cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
822
Views
5
Helpful
5
Replies

AP1242-ag as a supplicant

emilioramos
Level 1
Level 1

Hi,

How to configure LAP 1242AG to authenticate it self as a supplicante on the 802.1x interface switch?

Best regards,

Emilio

1 Accepted Solution

Accepted Solutions

Believe me I didn't see that "L". I think i should fix my broken glasses anyway

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"

View solution in original post

5 Replies 5

Amjad Abdullah
VIP Alumni
VIP Alumni

Emilio,

I fear this is not possible.

You can not configure the AP as a supplicant on the neighbor switch.

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"

stefan.angerer
Level 1
Level 1

Hi,

I think this is what you are looking for:

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70lwap.html#wp1366812

Configuring Authentication for Access Points

You can configure 802.1X authentication between a lightweight access  point and a Cisco switch. The access point acts as an 802.1X supplicant  and is authenticated by the switch using EAP-FAST with anonymous PAC  provisioning.

This feature is supported on the following hardware:

Cisco Aironet 1130, 1140, 1240, 1250, 1260, and 3500 series access points

[...]

Hope that helps!

Stefan

Ya this is for lightweight. I expected the question about autonomous APs i dont know why! Although not mentioned.

+5

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"

Emilio has written "LAP 1242AG" that's why I suppose we're talking about controller stuff.

Otherwise you're right of course

regards

Stefan

Believe me I didn't see that "L". I think i should fix my broken glasses anyway

Sent from Cisco Technical Support iPad App

Rating useful replies is more useful than saying "Thank you"
Review Cisco Networking for a $25 gift card