08-26-2011 04:17 AM - edited 07-03-2021 08:37 PM
Hi,
I have two AP1042 that I want to convert to lightweight, but I'm not able to find the software for that. I can only find the IOS software. Is it possible to convert? Is it located some other place?
Regards,
Patrick
Solved! Go to Solution.
08-26-2011 04:21 AM
Hi,
Here is the link to download the image..
Please dont forget to rate the usefull posts!!
Regards
Surendra
08-26-2011 04:21 AM
Hi,
Here is the link to download the image..
Please dont forget to rate the usefull posts!!
Regards
Surendra
08-26-2011 04:24 AM
Thanks Surendra, I didn't look at all the images.
08-26-2011 04:25 AM
ha ha Not a problem!!
Regards
Surendra
08-26-2011 05:00 AM
Since the AP uses the same software as 1142, I already had the right version, but I think it should have been a note on the download page fo 1042.
05-09-2014 04:26 AM
Hi Patrick,
Even im facing the same issue.
I have AIR-AP1042N-N-K9 can i convert it into lwapp.Please do suggest.
05-09-2014 08:58 AM
Vikas,
You can convert any of these AP's from autonomous to lightweight and vice versa. The requirement is that you need to be able to download the image. If you have the support to download, then you can follow one of these instructions:
Please rate helpful post and Cisco Support Community will donate to Kiva
Scotty
09-01-2014 09:26 PM
Hi Scott,
Thank u.....
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide