Wireless

Greetings Wireless Gurus of the Forum Got a good one for you(and please, don't just tell me 'to upgrade'... I know its OLD code... have to have justification for management, you know the drill... )Network Design: - see attached drawingWhat happens.Th...

Hi,I bought AIR-CAP3502E-EK910 wireless access point How I should orient the antennas in the two following cases- wall- ceiling Do you have any photos ? Thx Greg

                   En el aviso de end of sales de los equipos 1300 series.http://www.cisco.com/en/US/prod/collateral/wireless/ps5679/ps5861/end_of_life_notice_c51-711894.html te recomienda los equipos 1550 para enlaces punto a punto y la duda que ten...

Dear All,Currently, I'm developing Cisco wireless equipments in my customer. The devices is consist of :Wireless Access Pint --> AIR-LAP1252AG-A-K9 Wireless LAN Controller --> Cisco WLC 5508Wireless Control System --> Cisco WCS v.7.0.220.0 We put 2 a...

I have a 2504 WLC network 10.0.0.5/24, within this network I have full access to my WLC. Using the same host outside the network can not access. I can not ping this address I can ping any address within that network unless it Port 443 and 80 run thro...

I don't know why I cannot find an answer for this but, there are two controllers for this setup and they are in the same Mobility GroupWe have Two Conrollers Models 5508s and called them WLC1 and WLC2WLC1 = 192.168.1.10 ( Management IP )WLC2 = 192.16...

Hi team,I am currently working on configuring our Cisco Wireless control system to forward alarms as SNMP traps to Notification/SNMP servers. In WCS (Administration-> Settings -> Severity configuration), among several alarm conditions there are 2 con...

Hola Soy nuevo en esto, me gustaria saber la forma correcta de configurar 6 de estos equipos en modo repetidor, paara extender la red inalambrica, he visto las opciones que maneja este equipo y no las comprendo del todo si me pudirarn ayudar se los a...

Estimados, tengo configurado mi AP 1131ag con integracion RADIUS, funcionando ok, pero no esta entregando DHCP a equipo movil, se configuro tanto a nivel local como apuntando a server DHCP, aun asi persiste problema, estuve leyendo por ahi que se req...

Buen día,Saben tengo un AP1141 funcional con multiples VLANS, todas configuradas con WPA2, requiero en una de ellas hacer un filtrado MAC por lo que segui el siguiente manual: http://www.cisco.com/en/US/docs/wireless/access_point/12.4_21a_JA1/configu...