Wireless

Hi, I'm looking for documentation on the Enterprise mesh solution based on 7.0 MR1In this release e.g 802.11n APs are supported and clean air for the client radio etc...The current Cisco Mesh Access Points, Design and Deployment Guide is based on the...

Does WLC 5508 has capability to create login credentials with specific time of validity? Could it be used in hotel set-up to provide prepaid access account to guest?

Hi Guys, on my network, i have standalone AP's 1100 series. the problem is when i use network stumbler, there is one AP broadcasting at 99%this is no where to be found. i tried checking on the swithces but not trace of this. it is kind of weird.all t...

Does anyone have a working configuration between two BR1310's in Root/Non-root mode? The documentation is vary vague and i can't find anything more secure than WEP. Is it possible to use WPA with radius authentication?

HI  All ,I am new to wireless . I am using  WS-SVC-WISM-1-K9  wism module and using 5 Access points . When my clients are moving from one access point to another we are getting packet drops . Kindly anyone suggest me what all configuration i need to ...

Hello,    I have 3 WAP4410N,I want that clients to connect to the nearest access point, but it does not, the roaming not is working fine, and always connect to the same access point even if the signal is very low, how I can fix it?,  Do you think tha...

Hi all,I have two AP 1240s at a site, both with the same firmware and configuration, and all users are configured correctly to connect to the network. AP 2 is having some type of issue that is not allowing a complete connection to some of the users. ...

  I got following on fewer APs while other APs are working fine with same OS and WLC kindly guidecapwap ap ip address 152.109.100.11 255.255.255.224You should configure Domain and Name Server from controller CLI/GUI.amt_pkwalls1240AP011#capwap ap ip ...

I am using a Cisco 881G router with cellular card PCEX-3G-CDMA-V.The correct version of software is running according to the Cisco product overview documents: flash:c880data-universalk9-mz.124-22.T2.binWhile I am using the cellular connection surfing...

I have a wireless problem on the 800 series and with two PCs connected to the wireless router and you're a 40GB file to send by second PC over the wireless module does away is this normal?

I heard that it would be possible to configure WiFi-network in such a way it allows only devices of which the AP’s get a RX-signal that is above –xx dBm.This would prevent access from devices ‘far away’ eg: devices at BT office or Golden Tulip hotel,...

Hello to all, i  have a Problem with a wifi client.The client login successfully and the 26 seconds later the client recieve an idle timeout from WLC.*Dot1x_NW_MsgTask_0: Jul 15 12:53:22.471: 00:24:7e:a8:2a:2b x.x.x.x Adding Fast Path rule type = Air...