Wireless

Hi All,I'm afraid I may well be asking something that is fairly simply, the question is how do you reset excluded clients, the WLAN creation page (on WCS 6.0 at least) says in note 2 "....will require administrative override to reset excluded clients...

we added wism module in 6509 switch, butwcs cound not add wism(wireless controller).currently, wcs version is 4.2.176.0wism version is 6.0.182.0do you know why?No response from device, check SNMP communities, version or network for issues.error messa...

I was reading a wireless document that shows a design where 3 WAPs on a 802.11b/g network for 180 users.Best practices talk about 15 to 20 users per Access Point, which is what we typically do anyway.So, my question is can the Cisco 1230 or 1240 Acce...

Please refer to the this thread but thought it may be an idea to start a new one.http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&type=Subscriptions&loc=.2cc04897/6&forum=Wireless%20-%20Mobility&topic=GeneralSo, now I have my security poli...

We are investigating migrating from ISDN to 3G/UMTS access for a couple of remote sites and think the 3G-WIC will be a good substitute. According to the documentation you have to authenticate to the service provider through PPP to get IP-access. This...

hi to all!I'm trying to deploy many 1142 aps with 5500 controller. All aps will be near each other so it will be high ap density. To avoid interference issue i'm thinkingto activate RRM on controller and 40 mhz channel on 802.11n 5Ghz. With this conf...

Hi, i have WLC running IOS version 6 and bunch of AP (1142N, IOS 12.4(21a)JA) that i would like to shutdown at certain time. Eg. would like to have AP up at 6am and shut down at 7pm. Can this be done on WLC or on the switch where APs are connected to...

Hi,Is it safe to downgrade WLC 4402 software from 6 to 5.1? My problm is the web autentication through IAS server dosn't work - can't pass the authentication login window,it works before on 5.1Thanks.

Hi allI am having issues where, if I try to connect to a device plugged into my ap, via the workgroup bridge connection, I cannot ping it, however If I jump on the access point and run a ping to the device plugged into it, it is ok, then this brings ...

Hi Folks,I just spotted this on our WCS6.0MFP Anomaly Detected - 3,461 'Invalid MIC' violation(s) have originated from the AP with BSS '00:16:9d:44:65:d0'. This was detected by the radio with Slot ID '0' of the AP with MAC '00:19:aa:f5:5b:a0' when ob...

In our environment we have 4 4400 series wlc's. The first two (#001 and #002) run our standard shop floor profiles with 5 different vlans, and these access points are only deployed in our shop floor environments. These access points are all 1242 ap's...

We have a primary controller (4402 - 50) and a small 4402-12 setup as a anchor for guest access. All guest traffic (for Internet access only) is sent through the guest controller - located on our DMZ. Guest users were complaining that they were getti...

What does it mean when your 1131 access points are flashing orange or amber.Its not showing up on my 4404 controllers. I think its a bad run from the wireing closet to the ap.