Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I've got an SSID on my 1131 AP's (autonomous) configured with both WPA and CCKM for key management. All other clients have no issues. One laptop model (HP 2710) has intermitten issues failing CCKM authentication. The error in the log on the AP only s...

redwarrior by • Community Member
  • 644 Views
  • 1 replies
  • 0 Helpful votes

Hi, I am having problems with the coverage of a 1300 access point with a external 12dBi antenna.Basically that i need to know is how much distance (in meters) a 12dBi antenna should cover in a open space from the base.thank you

Hi There,I have 4404 WLC running 5.2,I have connected this WLC to a switch using LAG.My AP and WLC are on seprate segment.For illustration i can say Controller is on 192.168.50 and all my ap are on 142.240.83.0,Now 35 of my ap's connect to controller...

prabhjots by • Community Member
  • 876 Views
  • 2 replies
  • 0 Helpful votes

Folks, I am making plans to convert my wireless network from 802.11b/g to 802.11g only. I've done a fair amount of research and have discovered that there is a 66% performance hit when running mixed b/g mode compared to a stricty .g network. This is ...

c.fuller by • Level 4
  • 1506 Views
  • 4 replies
  • 0 Helpful votes

Hi Friend.I have a solution of 44 APs Cisco 1131 AG, and I have 2 WLC 4402, In both WLCs I have been configured 6 WLAN for each service that I have. All these WLANs don't have to make a SSID Broadcast, I wan to bind the SSID, but when into the WLAN c...

r.barba by • Level 2
  • 2453 Views
  • 10 replies
  • 0 Helpful votes

Hello, I have here an interesting issue. We have a mac address authentication scheme for our wireless structure and we have found that if a wireless client is not registered on the network, it sends multicast arp requests via the wired connection whi...

We have 1252 AP and we are trying to support N standard. For some reason the SSID is not broadcasted on the N. When looking at the client, we only see a/b/g but not n. Is there special configuration or hardware configuration needed to suppot N?The an...

fashour by • Level 3
  • 1916 Views
  • 7 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card