Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
i have a 7921 with app load id cp7921g-1.0.3.loads. The 7921 downloaded the configuring by tftp but soon it loses the wlan connection. Now it is in connection failed status. how to do for factory reset?Any idea? Regards
I have AP's on WLC4402 registered but clients cannot receive IP from DHCP on another subnet. (showing 0.0.0.0). Am not using WLC DHCP, have it configured under ap-manager interface and management interface.Could you please point me on where I'm faili...
Can some please clarify how Mobility groups work and when to use them. I have 2 data centers, each with a WLC, for centralized control. I just want to provide simple redundancy.When should I use an Anchor group.Thanks for your help.
I keep receiving alerts of IDS attacks on my wireless controllers as notified by my WCS. How can i stop these attacks?
Can anyone think of a reason why I would receive the error "No more AP Manager IP addresses remain"? I've had this error before when the correct interface for the AP manager was not configured, and I can see it happening if you were to put the AP Man...
Hello,I have two 1240's and they are bridged together, is there anyway to trunk across their link? I wasn't sure if there was a way to set them up to do trunking.Thanks,
Hi I have a problem.I have an AP which has 4 VLAN's on it which works fine. What I wnat to do is put in another AP with no ethernet attached into another building to act essentially as a repeater. The problem I have is that I do not want to use the n...
Hey, has anyone else experienced this after upgrading the firmware on the Wireless controller? I loaded AIR-WLC4400-K9-4-1-190-5-MESH onto the controller to follow the upgrade path and after it pushed the newer firmware to the AP it no longer boots c...
Hey All,Is there a way to de-authenticate with web-auth, and is there a timeout set? If so, how do you change it?Thanks,Scott
Hi,I have a colleague who accidentially purchased a number of 1130AG LAP access points. They have since converted them to autonomous and can now configure them.The problem now is that they appear in Cisco Network Assistant as "unknown devices". I am ...
The scenario is the next one: Ten access points and one WLSE Express. One is configured as WDS with a priority of 254, other access point as WDS with a priority of 128, and the other as Infrastructure AP's. The infrastructure AP's are authenticating ...
Has anyone tried the new feature in wcs 5 under configure AP's. You can use a csv file to bulk configure AP's.I'm running wcs 5.0 but my controllers are 4.2.112. Will this feature work, it would allow me to configure the names of more then 100 aps by...
I only found a conversation from 2005 which didn't end with a solution - maybe there is one in the meantime???I made a backup of the old server, put this on the new one, reinitialized the database on the new, made a "successful" restore of the DB - B...
Hi All, We are trying to change the default lease time of 1 day for the guest users created through lobby admin(In wireless LAN controller) .Is there a way to change that default time to some other value. Kindly let me know.Thanks RegardsAnantha Subr...
HiI want to setup a bridge between two sites. The root bridge which is installed at the first site cannot cover the second site's area. For this reason I want to use a repeater between these sites to increase the signal's strength.I have 3 aironet 12...
