Wireless

Hello, i have a problem with my WLSE device.it seens like db2 database fails to start.2004@WLSE:diag allDIAG: IMAGE *** PASS: Software image verification passed. ***DIAG: BIOS *** Drive model does not require BIOS patch. ***DIAG: DMA Checking disk fo...

Hi.When I connect to ASA from L2 Switch using IP sec Tunnel, I invocked the cli command, the session hang up, and then I can't L2 Switch , If I want to connect to L2 Switch again, I must reload L2 Switch.Is this a ASA Security function?I attached the...

HI ALL, I have 2 WiSM with some SSIDs. Till date everything was working fine..but suddenly today one of the SSID users complaining that they can not authenticate to SSID..on this SSID we have configured PEAP authentication where ACS is the external A...

I just read the release notes for WLC update 5.0.148.0 and I saw this line:***Cisco Aironet 1000 Series Access Points-The 1000 series access points are not supported for use with controller software release 5.0.148.0***Our entire network consists of ...

Hi,We are running a WCS appliance (Upgraded from WLSE) v4.2.62.0This is running a Linux Distro and I have found refernce to a file called ssl.conf from within httpd.conf for the SSL settings.Within this file is the Cipher setup string which include L...

Hi,I have a question about wireless WMM.... looking at a paper about it, the paper talked about 802.1p tagging... doesn't this assume that WMM is being used on a host that is trunking? Also, i read that WMM & DSCP qos on the AP can't be enabled at th...

Anyone seen the following problem?I've set it up for WPA-Enterprise (TKIP) and we get all the way through the authentication and the 4-way handshake, and then it sends me a group key which looks like this:0xaa 0xaa 0x03 0x00 0x00 0x00 0x88 0x8e 0x01 ...

Can we schedule a daily task to shut down and bring up the RF of the APs using WLC or WCS?

hi every body!can anyone give me a link on Lwapp? i did not have any luck on google. thanks alot!

Hi All,As I type the WCS Home page is reporting that I have a total of 59 rogue APs in the 'Rogue Detail Summary" table. However, when I click on the red underlined '59' WCS takes me to the rogue AP page and, guess what, the page is blank! Up until a...

Hi,I was just wondering if anyone has found a neat way of securing the Ap1010 access points?Does anyone sell kensington lock systems short enough to use on these?thanks,Matt

Hi,Could you please tell me how many channels are supported on one Cisco Aironet 1130AG...I means the numbers of users that could be supported by one Cisco Aironet 1130AG.Thanks in advanceBest RegardsMohamed

Do you know how many client can connect on a 1242 ap? I an deployment for conference room for 300 clients.