Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
AP1030WiSM 3.2.116.21I have an AP1030 that is losing connectivity to poor SNR. (I'm fixing that, the antenna was installed incorrectly)However, while Diagnosing it, I found this in the message logsWed Aug 23 18:30:49 2006 [ERROR] spam_lrad.c 1799: AP...
I've upgraded the software on my AP1231G-A-K9 with c1200-k9w7-tar.123-8.JA2.tar.The AP seems to work fine but when using QOS Voice scenarios I'm having a lot of problems that I don't see when using AP1232AG-A-K9 with the same software version.
Looking for a good program to convert AUTOCAD .dwf files into .jpg for importing into WCS. Having issues with Visio. Thanks
I configured my 1130AG as a DHCP server. The WAP is on a vlan. I am connected to a 2801 through an HWIC-4ESW-POE. My clients connect but I cannot access the Internet. As part of the DHCP configuration I identified my default router(gateway) using the...
I have observed newly-installed LAP-1131AG access points that have been "primed" to a particular controller. When we boot them up with the same WLC controller to which they are primed, they eventually turn light green (which according to the document...
I have a 1231G autonomous unit and a 4404 wireless controller, both reside on the same subnet, the controller is in layer 2 mode and has the bare necessities configured at present. I converted the 1231G to LWAPP, which was successful. But the LWAP wi...
Greetings,If I have two different WLANs, both configured for WPA-PSK, are the pre-shared keys different per WLAN?I ask because when I change the PSK on one WLAN, it seems that this may be affecting the other WLAN.I'm not on-site to test this out, unf...
Hi,I would like to setup 2 branch with hybrid reap access point.I did standardize the vlan assignment for the hybrid reap access point ( let say vlan 2).Since all the configuration done through WLC. Is there a way to configure using the same vlan id ...
Hello everybody,I am a bit confused about cisco 1000 series access point connection. On wireless lan controller and lightweight access point basic configuration example document id 69719 (http://www.cisco.com/en/US/products/ps6366/products_configurat...
We have a (brand new) WiSM blade installed in a 6509. The configuration looks ok, but when we try to register (join?) an AP with the controler the process fails. The controler shows the AP in the status display but the AP reboots, claiming that no jo...
As the title suggests, I can only get one wireless client to connect successfully to the AP when I am using WPA-PSK. The Client Computers (winxp sp2) attempt to connect, I can see the client attempts to connect to the AP, but they never get an IP add...
I'm trying to deploy an AP-1220B that's had issues for a long time; I seem to have isolated the cause to CRC errors on the Ethernet interface.I've attached the config of the WAP; can anyone point out any anomalies that need to be corrected? I've done...
Hi,I'm setting up my ACS server using MAC address to authenticate. I've over 1500 MAC addresses thus is there any way to mass import the MAC addresses into the ACS?With regards
could please anyone suggest me how to how to configure ip adresses for wlanwith 5 users.
