Wireless

I have a BR-340 bridge operating in bridge mode. This is one of the original units shipped right after Cisco took over Aironet but has been upgraded with the latest firmware.Works fine for several days and then loses association and has blinking red ...

Hi all,Can anyone tell me whether 802.1x standard is supported by Avaya switches or not?Does 802.1x is only possible with cisco.Regards

Why the WGB 350 filters do not understand PPPoE session protocol ?When i block protocol number 0x8864 (PPPoE session) nothing happens. Packets still forwarded by the workgrou pbridge. When i do protocol monitoring on my WGB it isn't show the 0x8864 p...

Any one knows whether this handheld device can work in a WLAN with PEAP or VPN or LEAP envit seem like a appliance that runs DR-DOS in it

I would like to monitor APradio freq to provide me an alert in case it fail, As some of my AP fail to assoc to user need to remove the restart the ap again, any body know why?RegardsMcNAz

Are there any documentation available how to handle a WLAN network on daily basis ?What I feel I need to know is:Usage (how are my network utilized)Quality (what quality does the network deliver)Availability (Is the network available for the users)I ...

I am trying to enable static WEP on my 350 series AP and a Windows XP client also using a 350 series PCMCIA card.I can associate with the AP with no encryption on either device, but as soon as I enable WEP with the same keys on both devices, I cannot...

Trying to assosiate 2 350 Bridges, when one of them was Root Bridge and the other Root Access Point, I got the following error:"Too many stations in BSS area"Changing the roles, the first one became Root AP and the second one Root Bridge, I got the a...

Could somebofy tell me if there is a way to save LEAP id and password when usign Cisco Aeronet 340 adapter on Pocket PC? I do this on Windows 2000 using LEAP Settings dialog of the ACU. However, I've been unable to find a place where I could do it on...

I have problem with LEAP authentication between my Cisco wireless group devices and Win 2k Adv Server. On my Win 2k Adv Server in EAP methods there is only one authentication methods MD5-Challenge. Maybe someone knows how to install another authenti...

Hi,How do i connect the following : Bldg A ------> Bldg C (serving as a repeater) --------> Bldg D Bldg B ------->Do i need to deploy all the wireless access point as workgroup bridge (for bld...

I have a 342 AP that when powered up, you can see it and try to associate for about 3 secs. after boot process, then it disappears and the only thing that can see it is the other 342 that is in range of it. No clients can see the device using either ...

I'm running IAS on Win2K server (added patch for PEAP suppport, box is a domain controller in an Active Directory); XP client with SP1; Cisco 352 (tried firmware 12.01T, 11.23 so far); tried both a Cisco 352 card and a Linksys card.In the event viewe...

Is ther any way to authorize client using it's logon information, using the same domain server than the one used for login pourposesThanks in advance

Hello,I have two bridges that will connect between two sites that are less than one mile apart. My question is what can I use to test signal strength and help me fine tune antenna alignment. I only have the two bridge units for this test. Any help...