Wireless

We are currently in the process of upgrading 27+ wireless access points to the IOS based interface. Everything seems to be going smootly, except in the Aironet Client Utility, at the bottom of the window where it says what AP I am currently associate...

since there is no b/g integral antenna for 1200 (1231g) AP i wanna know what kind of dipole omnidirectional antenna i can use for ceiling mount(product part number) i really appreciate your opinions.

Could someone please let me know what a good inexpensive tool for radio frequency scanning.Thanks

Hello We currently using SSG/SESM (12.3 ios & 3.2) for PWLAN with centralised architecture. So, we are planning to make some roaming peerings with other networks. The problem and the major issue is that the SESM/SSG is not supporting the WISPr attrib...

Dear Sir,My company has setup wireless LAN for the past one year. Each floor has one AP 1200. The connection is fine and the quality is satisfactory. We have a mixture of wireless clients such as Cisco, 3Com, Agere and third party vendor.We are using...

I have taken over a network with 20 Aironet 1200 Access Point, which I believe they were upgraded via a module to support B/G wireless along with A support. I have no wireless experience. Our old laptops have Cisco wireless A cards which works perfec...

We operate an infrastructure network with several dozen APs supporting many roaming users. We must therefore have all the APs supplying the same SSID in order to roam. We have recently added several fixed location Sony webcams with Aironet 350 cards ...

Hi folks,I've been reading that the 350 series bridges are not compatible with the old 340's. Is this true?I have a network link with a 350 and a 340...they work...but not very well. The compatibility issue is true ?Thank you.Francisco.

I like to use my aironet 350 in repeater (bridge) mode to my linksys WRT54G. I configured my WRT54G as an 802.11b ONLY node. Are there any problems to be expected?

There is a recommended Cisco QOS template for connecting access points to 802.11b AP's which polices the amount of traffic going out to the AP to 6 Meg. Is there a similar document for 802.11g AP's bearing in mind that with no 802.11b devices attache...

Hi all,I've got a Cisco Aironet 350 PCMCIA wireless network card. When I try to install the appropriate drivers and Cisco tools, the setup program stops at every tool install box with the error "Catastrophic Failure".Specs:Cisco Aironet 350Windows XP...

How do i set values for the following using SNMPfor a cisco 1100 AP.IpAddressGatewaySNMP CommunityHTTP,SNMP Enable/DisableSNMP Trap Destination AddressCan anyone point me the mib used for this

Dear Sir,Hope that you can advise me.My wireless setup is as follows:-An Omni 12 dBi antenna is mounted on top of a pole along highway. A coaxial cable is interconnecting the antenna and a lightning arrestor before reaching the access point 1200. The...