Wireless

What is the best wireless scanner that will work on my Ipaq? I need to be able to find rogue devices that are in my network that I don't want. I at least want to detect 802.11b and anything beyond that is a plus.Any suggestions?

Today I downloaded the 12.04 firmware for the 1200 and 350 AP's. The 350 download has the IMG file however the 1200 is missing the IMG file. Can anyone point me to where I can download the latest 1200 IMG file.Thanks,

I have not seen any new package updates for the 2.30 PCMCIA/Laptop package on the TAC Software Download section. 2.30 works fine with PocketPC 2002, but will not install on 2003. Has anyone gotten this work? Is a driver availabe? Any news of an ACU f...

Hi,Is it possible to deploy a wireless network with more than 90 APs with no single wire? The throuhput will be cut by half for each repeater, so is there any way to deploy it without any wires linking each AP?Thanks in advance

I have heard that if you install the new 802.11g radio module into an existing 1200 that runs 802.11b, the most you will get from throughput is still only 11Mb. Is that true? If this is true, is there a way to switch the exhisting internal 802.11b ra...

Spanish regulations require DFS (dynamic freq. selection) support in the APs to transmit more than 30mW EIRP in the 5.15-5.35GHz band.Is DFS supported in IOS 11.2(13)JA?Regards,Jose M.

I have 16 Ap 340 with 11.07 software and 1 Ap 1100 with 12.02 software in one building,All Ap 340 loss connection about 5 seconds to ethernet backbond and sometimes must be hard booting to connection agains.But the Ap 1100 have stable connection all ...

I have a BR350 with about 50 wireless clients linked with wireless PCI Adoptors. Both are CISCO devices. Lately i have been experiencing a lot of disconnects, especially at peak periods. Disconnects occurs radomly, however the clients that get into t...

hello,i have a problem with my card, i have it on a Dell 5100 (laptop) first:The card does not auto fall back when the range is far, it always stays connected at 11mbps, so that makes the range so weak. i have tried every possible configuration, but ...

I set up my Linksys wireless AP to be a CLIENT to AP 350. Both operates in the same channel. In the Event Log of AP350, I noticed both devices show several attempts to associates/Dissassociates. Does a difference in transmit power in both devices cau...

I tried to set up my LAN with a Linksys wireless b router but it is not producing a signal strong enough to reach a back office (best I get is 30%, usually 12-17%)There are walls (brick and glass) in the LOS. The linksys booster actually lowered the ...

I am planning to install the Aironet 1200 series product in my office. I need to determine how to size my system. What is the number of PC's supported by each AP? I will be running 802.11a.

Hi all,My question:Can I use the BR340 bridge (root bridge) and one AP350 (nonroot)to connect two LAN segments?