Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
Hi to everyone,I'm involved in a WLAN project. I'm working in the QoS field and in 802.11 a way to grant some QoS is the use of PCF (even if it's not the best way).Do all the APs have the PCF built-in?How can I modify PCF parameters? (I've downloaded...
Hi! The non-root bridge (11.23T) which is connected to a Dual-Speed Hub send about every minute the message to my syslog server: BR350-JM-AKV (Info): Started driver for port "fec0"<000> BR350-JM-AKV (Info): Stopped driver for port "fec0"<000> I´ve tr...
Got two airo 350's back to back in adhoc mode everything worked just fine. Worked yes, untill recently all of a sudden I get the following message in the syslog.airo : BAP setup error too many retries.Nothing, that I can think of, has changed. Runnin...
Is it posible to Downgrade the Firmware on a 350 Series PCI Wireless Adaptor Card
I tried to implement a solution to authenticate both MAC address and LEAP for wireless client using Cisco ACS. However, it seems that as long as LEAP authentication passed, no matter the MAC authentication was configured properly or not, the user cou...
We are going to deploy Wireless on our network. Beside the suggested Cisco policy for securing wireless we also want to to secure it with VPN. Has anybody done this that can point me where to start. We have a 3000 concentrator, can I user the externa...
When using Aironet 350 PCMCIA card as my network device for Enternet PPPoE client, my PC gets very slow each time traffic is transmitted. I do NOT have this problem when using the wireless card without the PPPoE client (ie within a LAN). Is it a know...
Hello, I have not devices to test and i have a question: Can I use two devices configured as repeaters in a hot-standby redundant configuration. I think that's only possible if the standby one monitors the main device via Air-interface (i think that'...
What does it mean "Wireless Bridge in AP mode"? Is it same with "Wireless Bridge in Repeater mode" or not? What is the different? (In point-to-multipoint environment)Which devices can associate with Wireless Bridge in Root mode and which with Wireles...
Hi, with the above WLAN Equipment installed, there are approx. twice a minute a link loss. But not with Labtops with the same PCM352 and WIN 2000 is installed. Has anybody a clue abaout this issue. Regards Richard
What is the OID for the ethernet port/radio port on the Ap 350/1200 or 340.How can i find it using snmpwalk or snmpget ?
I recently depolyed two labs each lab has 2 1200 access points set up as roots and 30 pcs. I have the power set to 30mw on each access point. The problem I am having is when students log in in these classrooms at the same time it takes about 6-8 minu...
I have two Aironet 340 Point Access and I want connect two wired LAN that are in different buildings.I have configurated: -> 1 acces point / root -> 1 client / non-rootThe "association menu" say: The client is associated with the access point, but th...
Just wondering if you can distribute WEP keys to AP's without going to each AP.
I am configuring a number of Cisco AP 350s for Cisco LEAP. If "Rotate Broadcast Key" is enabled, is it necessary to enter a static WEP key to be used to encrypt broadcast/multicast packets? If Cisco LEAP only is required (Network EAP is enabled as an...
