Resolved! WLC2504 Dynamic Vlan
I successfull create dynamic vlan on WLC 9800, but it's not work for WLC 2504. Should i create dynamic interface group on WLC 2504 for dynamic vlan?
Forum Posts
So we are investigating client ipads roaming unecessarily to nearby APs. All of our APs are in an indoor RF Profile:We've been running this way for a few years without issue. All of our APs are set to Auto:But today I noticed that they all seem to ...
I have an open SSID for guests and marketing wants us to push everyone to a splash page after they connect. I can't think of a way to make it work without an authentication process. Does anyone know how I can do this?
Hey all,We have 9800 WLC running IOS XE 17.9.3 and a few models of AP's ranging from 9115's to 9124s, 9164s, etc.We use flexconnect everywhere and all traffic is switch on the local LAN at each location. No Local mode/central switching in our environ...
Hi everyone,I am having a frustrating issue with a Cisco Catalyst 9120AXE Access Point console connection.When I boot the AP, I can see the full boot sequence text scrolling normally on my screen at a baud rate of 115200. However, once it finishes bo...
CW9172I has increased cabling sensitivity and experiences PoE detect issues in some cases when connected to cat6 that is within specification according to cable analyzer results. This manifests itself in the AP failing to be detected by the PSE for h...
Good day-A local City provides free public WiFi at many of their parks. This topology includes:Meraki MR76, most of them 1 Gbps ethernet, 1 or 10 Gbps uplinks from access switches in parks to 10 Gbps at distribution layer to 100 Gbps to core layer o...
Hi Team, i did an upgrade to 17.15.4d from 17.15.3. Since then, the Client Counter at the Dashboard is different to the Counter in the Client Detail List. The Pages beyond are empty and the Client Export shows only the ~1000 Clients. Has anybody see...
Hi,I have 10X 2702I APs reporting high CPU utilization while other AP models are fine. the WLC is C9800 17.12.6aPlease assist
We found this AP down on 09-Aug-2026 (UTC+7). We then checked the switch port connected to this AP, which also showed as down.
Hello, we have a bunch of Newline Ultra Q boards, which are newer than the Q boards we had, these are running Android 16. The SSID we connect the devices to is MAC Filtered through ISE, it has policies for the device and everything. The device connec...
We ahve installed some 16 new MR 57 at 2 different locations, and they all stayed dormant, even though the ports where they are connected show the APs with a valid IP address from the correct Vlan, and these IPs are pingable from Meraki and from outs...
Resolved! Wireless Profile with mixed EAP types
HiWe have a Cisco 9800/Cisco Lightweight network. The main wireless profile is used by devices that are a mixed of managed (Intune) and BYOD and runs 802.1x EAP-PEAP using Cisco ISE 3.3 for AAA services. I have been asked to roll out EAP-TLS for th...
Bonjour,J'ai récupéré un point d'accès Cisco Aironet AIR-AP3802I-E-K9 d'occasion (pas acheté auprès d'un revendeur, aucun contrat de support associé à l'appareil). Il tourne actuellement en image CAPWAP (Cisco AP Software, ap3g3), confirmé via show i...
Hello community,We would like to get your guidance on the following customer requirement and understand how this could be implemented using Meraki. The customer manages its Windows devices through Microsoft Intune and would like to authenticate machi...
