
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-27-2022 01:46 AM
Hi
Is there any way to display cdp information of APs on c9800 (17.6.3) controller in GUI? I am looking for the command output of "sh ap cdp neighbors" in the GUI.
AirOS based WLCs had an option to view this on GUI Home> Network summary > Access point view - I am looking for similar option on catalyst based WLCs
TIA - Rajesh
Solved! Go to Solution.
- Labels:
-
Catalyst Wireless Controllers
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-27-2022 03:01 AM
You may navigate as shown in the above screenshot
TAC recommended codes for AireOS WLC's
Best Practices for AireOS WLC's
TAC recommended codes for 9800 WLC's
Best Practices for 9800 WLC's
Cisco Wireless compatibility matrix
___________________________________________
Arshad Safrulla
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-27-2022 02:02 AM
There is a "Make a Wish" option on the 9800 GUI page.
Alternatively, reach out to your Cisco AM/SE/PSS and ask them to create a PER in your behalf.
Good luck.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-27-2022 03:01 AM
You may navigate as shown in the above screenshot
TAC recommended codes for AireOS WLC's
Best Practices for AireOS WLC's
TAC recommended codes for 9800 WLC's
Best Practices for 9800 WLC's
Cisco Wireless compatibility matrix
___________________________________________
Arshad Safrulla
